Sony Trinitron KV-27TW77 Manual page 57

MUTIhG_) (_SLEEP
__.___
TV/VIDI-'O "TV CABLEPOWER
@®@
@®®
DISPb_¥
VOL CH
3HGUIDE_ 0
JUMP
C00E !lET CABLEBOXTV
_ _ c_%
CH AUDIO WNIDEO
CH • II
•<h< b,-
REC • TV/WR
RM-Y118
Manufactures and Code Numbers (cable box)
_m_qmlm
JERROLD
PIONI-ER
SCIENTIFIC ATLANTA
TOCOM
ZENFH
60,61,62,63,64,65
69,70
66,67
71,72
68
Follow these instructions to set the manufacturer's code which will enable you to
operate a connected cable converter box with the pre-programmed Remote
Commander.
EXAMPLE: Operate a connected Zenith cable converter box.
1
Set the CABLEBOX-TV selector to CABLEBOX.
CABLEBOX TV
• If more than one code number is listed, try entering them one by one until you come to
the correct code for your equipment.
• If you enter a new code number, the code number you previously entered at that setting is
erased.
• In some rare cases, your equipment may use a code that is not provided with this
Remote Commander and you may not be able to operate your cable converter box with
the supplied Remote Commander, In this case, use the equipment's own remote control
unit.
While pressing CODE SET, press 6 and 8 (Zenith's cocle number -see chart below) and ENTER.
oooese, +
Use CABLE POWER and the TV control buttons (0 -- 9, ENTER, JUMP and
CH +/-) to operate the cable converter box.
CASLEPOWFR © ® ® JUMP CH
®_
To operate the TV
Set the CABLEBOX-TV selector to TV, then use the TV control buttons to control
the TV.
For more details on operating the cable box
Refer to the operating instructions that come with the cable box.
=___
==
"o
m
"10
€:}
u=l
.--t
3
3
==.
Chapter3: Using Advanced Features
57