Troubleshooting - Snapper HWPS26600RV Safety Instructions & Operator's Manual

PROBLEM
Engine Will Not Start
Using Recoil Starter
Engine Stalls or Stops
After Running
Engine Loses Power
Excessive Vibration
Mower Will Not Move
Loss Of Traction
(Self-Propelled Models)
Cutting Grass
Improperly
Poor Grass Discharge
Oil Leaking
TROUBLESHOOTING
1.
2•
3.
4•
1.
,
3.
4.
5.
1
2.
3.
1
2.
3•
4•
5•
1
2•
3•
1•
2•
3.
4.
5.
6•
1
2.
3.
4.
5.
6.
7.
1.
PROBABLE CAUSE CORRECTIVE ACTION
Fuel tank empty or fuel valve OFF. 1. Fill fuel tank with fresh fuel• Turn valve ON.
Engine needs choking. 2. Move choke control to "CHOKE" position•
Spark plug wire disconnected• 3• Place spark plug wire onto spark plug.
Engine speed control in STOP position• 4. Move control to choke or fast position•
Choke control in the "CHOKE" position• 1. Move choke control to "OFF" position•
Fuel tank empty• 2. Fill with fuel to proper level•
Engine air pre-cleaner and or air cleaner dirty. 3. Clean free of all debris•
Spark plug defective or gap set improperly• 4. Service spark plug.
Water, debris or stale fuel in fuel system• 5. Drain and clean fuel system•
• Engine air pre-cleaner or air cleaner dirty. 1. Clean or replace filters•
Spark plug faulty• 2. Service spark plug.
Water, debris or stale fuel in fuel system• 3. Drain and clean fuel system•
• Damaged, out of balance or bent mower blades• 1• Service mower blade(s).
Loose blade components• 2• Service and tighten loose parts•
Loose or missing air lift (if equipped)• 3. Replace air lifts• Tighten to proper torque•
Lumpy or frayed belt. 4. Replace belt.
Bent Idler pulley• 5. Replace pulley•
• Damaged transmission• 1• Contact authorized SNAPPER dealer•
Traction drive belt requires replacement• 2. Replace traction drive belt.
Driven disc slipping. 3. Clean or replace driven disc.
Cutting height too low or high. 1• Adjust cutting height•
Engine speed too slow. 2. Move engine speed control to "FAST" position•
Forward ground speed too fast. 3. Move ground speed control to a slower speed•
Terraced cut, side to side. 4. Adjust height of cut with height adjust levers•
Excessive deck pitch, front to rear. 5• Adjust height of cut with height adjust levers•
Cutting blade(s) dull or damaged• 6• Sharpen cutting edges or replace blade(s).
• Engine speed too slow. 1. Move engine speed control to "FAST" position•
Forward speed too fast. 2. Move ground speed control to a slower speed•
Grass is wet• 3• Mow when grass is dry•
Excessively worn or damaged blade(s). 4. Service mower blade(s).
Build up of grass clippings and debris under deck. 5. Clean deck.
Improper blade(s) installed on deck. 6. Install proper SNAPPER blades•
Blade(s) installed improperly on deck. 7. Install blades properly•
Leaking engine case. 1. Contact authorized SNAPPER dealer•
2. Check and tighten drain plug.
3. Make sure dip stick or oil filler cap is securely
in place•
19