Snapper LT120G30DB Safety Instructions & Operator's Manual page 14

Lawn tractor hydrostatic & gear drive series d
Table of Contents

Advertisement

TROUBLESHOOTING
BLADE(S) NOT
CUllING
CUTTING GRASS
1.
IMPROPERLY
2.
3.
4.
5.
6.
7,
8.
POOR GRASS
1.
DISCHARGE
1.Blade engagement leverin the "OFF" position.
2, Blade belt requiresadjustment.
3. Blade belt requiresreplacement.
Uneven tire pressure.
Cuing
height too low or high.
Engine speed too slow.
Forward speed too fast.
Deck side to side level requires adjustment.
Deck front to rear level requires adjustment.
Blade belt requires adjustment.
Blade belt requires replacement.
Engine speed too slow.
2. Forward speed too fast.
3. Grass is wet.
4 Excessively worn or damaged blade(s).
5. Build-up of grass clippings and debns under deck.
6. Improper blade(s) installed on deck.
7. Blade(s) installed improperly on deck.
BATTERY
WILL
NOT
1. Poor cable connections.
CHARGE
2. Bad battery cell(s).
OIL LEAKING
FROM
TRANSMISSION
1. Move leverto the "ON" position.
2. Adjust mower belt.
3. Replace mowerbelt.
1. Bring to proper pressure.
2. Adjust cuttingheight.
3. Move engine speed oontrol to "FAST'.
4. Move speed controlto a slower speed.
5. Adjust side to side level.
6. Adjustfront to rear level.
7. Adjustblade belt tension.
8, Replace blade belt.
1. Move engine speed oontrol to "FAST".
2 Move speed control to a slower speed.
3. Mow when grassis dry.
4.Service mower blade(s).
5.Cleandeck.
6.Install
proper SNAPPER
blades.
7.Install
blades properly,
I.Cean cables and battery t erminals.
2. Replace with new battery.
3. Faulty alternator.
3. Contact
engine manufacturer's
dealer.
1. Loose or missing oil filler cap. (Hydro Models Only)
1. Check oil level and replace oil cap.
2. Leaking axle seals.
2. Contact authorized SNAPPER
dealer.
3. Leaking at casing seal
3. Contact authorized SNAPPER
dealer.
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents