Samsung SPL4225 Owner's Instructions Manual page 33

When Key Lock is set to ON the buttons (SOURCE. MENU. VOLUME. SELECT. MUTE. POWER) on the
front of the PDP will not opera[e, However. these buttons will operate when setting Key Lock OFF.
Press the Menu button. Move the joystick up or
down to select "SETUP". then 3russ the Joystick
to enter.
Move thejoystick up or down to select "Key Lock".
/J then move thejoystick left or right to select
"On" or "Off .
Press the Menu button to exit.
64
This PDP% remote control can operate almost any VCR, cable box, or DVD. After it has been set up
properly, your remote control can operate in four different modes :Monitor, VCR, Cable, or DVD. Press-
ing the corresponding button on the remote control allows you to switch between these modes, and
control whichever piece of equipment you choose.
Note'fhe remote contrc4 may not be compatible with aft DVD Pfayc, rs, VCRs, Cable boxes.
SettingUpthe Remoteto OperateYourVCR,Cablebox,or DVD players
Turn off your VCR. (or Cable box, DVD player.)
Press the MODE button and make sure that the VCR t,#,,,_;_ VCR Ch_ I>VD
(or Cable box, DVD) LED is illuminated. <}::i}
3
4
5
iiiiill iii_i!ii_! !
Press the Set button on your PDP's remote control, sEf _&e_iu_. s=l_,._h z_,fl_, I
Using the number buttons on your remote control, _C_'__
enter three digits ofthe VCR (or Cable box, DVD) _ _
code listed on page 64 of this manual for your
brand of VCR (or Cable box, DVD player). Make
firstSure digitY°U e nteris a "O".threedigits of the code, even if the
(If more than one code is listed, try the first one.)
Press the Power button on the remote control.
Your VCR (or Cable box, DVD player) should turn
on if your remote is set up correctly. If your VCR (or
Cable box, DVD player) does not turn on after set
up, repeat steps 2, 3, and 4, but try one of the other
codes listed for your brand of VCR (or Cable box,
DVD player).
If no other codes are listed, try each code, COO
through 089 (or Cable box: 0000 through 077,
DVD player: 000 through 008).
Notes
• When your remote control is in "VCR" mode, the VCR control buttons (Stop, REW, Play/Pause, FF)
still operate your VCR.
• When your remote control is in "Cable box" or "DVD" mode, the VCR control buttons (Stop, REW,
Play/Pause, FF) still operate your VCR. 65