Samsung SPL4225 Owner's Instructions Manual page 3

• Protect the power cord. Power supply cords should be routed so that they won't be walked on or pinched
by objects placed on or against them. 3ay particular attention to cords at plugs convenience recepta-
cles. and the point where they exit from the unit
• Unplug the Monitor from the wall outlet and disconnect the antenna or cable system during a lightning
storm or when left unattended and unused for long periods of time. This will prevent damage to the unit
due to lightning and power-line surges.
• Avoid overhead power lines. An outside antenna system should not be placed in the vicinity of overhead
3ower lines or other electric light or power circuits or where it can fall into such power lines or circuits.
When installing an outside antenna system be extremely careful to keep from touching the power lines
or circuits. Contact with such lines can be fatal.
• Do not overload the wall outlet or extension cords. Overloading can result in fire or electric shock.
• Do no[ insert anytl-ing through the openings in the unit. where they can touch dangerous voltage points
or damage parts. Never spill liquid of any kind on the Monitor.
• Ground outdoor antennas, f an outside antenna or cable system is connected to the Monitor. 3e sure the
antenna or cable system is grounded so as [o provide some protection against voltage surges and built-
up static charges. Section 810 of the National Electrical Code. ANSI/NFPA No.70-1984, provides infor-
mation about 3roper grounding of the mast and supporting structure, grounding of the lead-in wire [o an
antenna discharge unit. size of grounding conductors, location of antenna discharge unit connection to
grounding electrodes, and requirements for the grounding electrode.
• Do not attempt to service the Monitor yourself. Refer all servicing to qualified service personnel. Unplug
the unit from the wall outlet and refer servicing to qualified service personnel under the following condi-
tions:
- when the power-supply cord or plug is damaged
if liquid has been spilled on the unit or if objects have fallen into the unit
if the Monitor has been exposed to rain or water
if the Monitor does not operate normally by following the operating instructions
- if the Monitor has been dropped or the cabinet has been damaged
- when the Monitor exhibits a distinct change in performance
• If you make adJustments yourself, adjust only those controls that are covered by the operating instruc-
tions. Adjusting other controls may result in damage and will often require extensive work by a qualified
technician to restore the Monitor to normal.
• When replacement parts are required be sure the service technician uses replacement parts specified by
the manufacturer or those that have the same characteristics as the original part. Unauthorized substitu-
tions may result in additional damage to the unit.
• Upon completion of any service or repairs to this Monitor. ask the service technician to 3erform safety
checks to determine that the Monitor is in a safe operating condition.
• The PDP can properly operate within the temperature range of 32-104_F and humidity 80%.
Do not use in a hot and humid place.
User Instructions
The Federal Communications Commission Radio
Frequency Interference Statement includes the fol-
lowing warning:
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 1 5 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a resi-
dential installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communica-
tions. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If
this equipment does cause harmful interference to
radio or television reception, which can be deter-
mined by turning the equipment off and on, the
user is encouraged to try to correct the interfer-
ence by one or more of the following measures.
User Information
Changes or modifications not expressly approved
by the party responsible for compliance could
void the user's authority to operate the equipment.
If necessary, consult your dealer or an experi-
enced radio/television technician for additional
suggestions. You may find the booklet called How
to Identify and Resolve Radio/TV Interference
Problems helpful. This booklet was prepared by
the Federal Communications Commission. It is
available from the U.S. Government Printing
Office, Washington, DC 20402, Stock Number
004-000-00345-4 .
Warning
This is a Class B product. In a domestic environ-
ment this product may cause radio interference in
which case the user may be required to take ade-
quate measures.
User must use shielded signal interface cables to
maintain FCC compliance for the product.
Declaration of conformity for products marked
with FCC Logo. This device complies with Part 15
of the FCC Rules. Operation is subject to the fol-
lowing two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
The party responsible for product compliance:
SAMSUNG ELECTRONICS CO., LTD
America OA Lab of Samsung
3351 Michelson Drive, Suite #290,
Irvine, CA 92612, U.S.A
Tel) 949-975-7310
Fax) 949-975-7328
Provided with this monitor is a detachable power
supply cord with IEC320 style terminations.
It may be suitable for connection to any UL Listed
personal computer with similar configuration.
Before making the connection, make sure the volt-
age rating of the computer convenience outlet is
the same as the monitor and that the ampere rat-
ing of the computer convenience outlet is equal to
or exceeds the monitor voltage rating.
For 110 Volt applications, use only UL Listed
detachable power cord with NEMA configuration
5-15P type (parallel blades) plug cap. For 230
Volt applications use only UL Listed Detachable
power supply cord with NEMA configuration
6015P type (tandem blades) plug cap.
IC Compliance Notice
This Class B digital apparatus meets all require-
ments of the Canadian Interference-Causing
Equipment Regulations of ]CES-O03.
Notice de Conformitd IC
Cet appareil numerique de Classe B respecte
toutes les exigences du Reglement ICES-003 sur
les equipements produisant des interferences au
Canada.
European Notice
Products with the CE Marking comply with both
the EMC Directive (89/336/EEC), (92/31/EEC),
(93/68/EEC) and the Low Voltage Directive
(73/23/EEC) issued by the Commission of the
European Community. Compliance with these
directives implies conformity to the following Euro-
pean Norms:
• EN55022 : 1998 Class B
• EN55024 : 1998
• EN61000-3-2 : 1995
• EN61000-3-3 : 1995
4 5