How To Assemble; Attach Handle; Attach Hose - Sanitaire System_Pro SP5816 Owner's Manual

HOW TO ASSEMBLE

CAUTION: Assemble the cleaner before using.
Moving parts, make sure on/off switch is
in off (O) position before plugging in.
NOTE: Features may vary by model yet all parts
assemble the same.

Attach Handle

CAUTION: Do not catch cord under handle.
2
1. From rear of cleaner, align handle with groove and slide
onto cleaner. If necessary, use thumb and fi nger pressure
to slide handle into position.
2. Attach handle with the two 1 inch screws provided in the
assembly packet. Use a Phillips
NOTE: Hand tighten with screwdriver to be sure
both screws are fi rmly seated.

Attach Hose

3. Pick up hose and lay across upper hose retainer.
4. Push the end of the hose in the lower hose retainer to
secure.
4
1
Grooves
head screwdriver.
®
3
Upper Hose
Retainer
4
Hose
Lower Hose Retainer
Store Hose and Accessories
Dusting
Brush
Store Electrical Cord
Cord
Retainer
5. You will fi nd your cord retainer on the handle above the
upper cord hook. Firmly push the electrical cord down
into the cord retainer. This will place the cord out of the
way the next time you vacuum.
6. Next wind the cord around the two cord hooks on the
back side of cleaner.
7. Secure the plug to the cord to prevent unwinding. 7. Secure the plug to the cord to prevent unwinding. 7. Secure the plug to the cord to prevent unwinding.
Nested Wands
6 Cord Hook
Plug
7
6
Cord Hook