Assembly - Remington BRANCH WIZARD 111409-01 Owner's Manual

A_EMBLY
IMPORTANT: Read and understand this
manual before assembling or operat-
ing this Pole Saw° Improper use of Pole
Saw can cause severe injurg, Keep this
manua! forfutur_ r_f_r_nee_ __
Note: Some models are pre-assembied Assembly
is not needed on these models
See &_, Chain Ten_ionAdjustment
Cutting edges on chain
I_ CAUTION: Do not place chain on saw [
1
backwards_ If chain is backwards, saw
/
wi!l vibrate badly and will not cut.
5 Place Belleville washer, sprocket cover, and
guide bar nut onto Pole Saw. IMlaORTANT;
Make sure serrated edge of die Belteville washer
is positioned as shown in Figure 3 The serrated
edge must he in contact with the guide bar
IMPORTANT." Tighten guide bar' nut finger tight
only
6 Adjust saw chain tension Follow steps under
Saw Chain Ten_ion Adju_mwnt
I IMPORTANT: Do not Pole Saw in [
I
clamp
vise during assembly.
I
l,
2
3
4
Lay eh,_in out flat.
Loosen and remove guide bar nut, sprocket
cover, and washer (see Figure t)
Inst,'tl! guide bar onto saw body, Place center slot
of guide bar onto guide bar bolt.
Place chain around drive sprocket, then along
top groove of guide bar and around guide bar
nose Note: Make sure cutting edges of chain
are facing the right direction Position chain so
cutting edges on top of guide bar face guide bar
nose (see Figure 2 and indicator on side cover
of Pole Saw)
Figure 3 * Befleville Washer Assernbhy
Saw Chin
www rem}ngtonpowenoo_s.eom 8