Table of Contents
Advertisement
Connections
& Setup
w;_ _,neus yo_-TVtuned tov,h_ _
t]_e cable
box?
02
03
3,
Highlight the channel to _',hich you have to tune your TV in order to see
cable
progtall111 3g, n(. press OK (a screen appears
]'emindhag you lo
connect
your G-LINK cable to your TV and cahle boxt.
Note:
Channel
()._ is the
I st cOtlllnon.
attmY, t_fq retdw _t _m,
ktlr_. If_u t_ r_
lilt _
box_',t_ _
tt,m_ _tr (ab_pt_4_-
4.
Highlight your brand of cahle box. and press OK.
If your hrand isn't listed, high g it A'ot Listed ant! press OK.
,
Make sure your cable box is on.
Tune the cable box to channel 02 (use the remote control that came with
your cable box, or press the channel buttons
on the cable box).
Press OK (the GUIDE Plus+ system starts testing codes).
Important
Note:
When code testing is in progress, don't touch your TV,
VCR, cable box or any of the remote controlsJbr
tb_'seproducts.
,
Look at your cable box. If it is still on and changed
to channel 09, the test
was successful.
Highlight
Yes, and press OK (STEP 3: Configuring for a VCR
appea_).
If your cable hox didn't change to channel 09 or turned itself off, you have
two choices:
No and Test this code again.
Test this code again.. If you think the TV, the cable box, or any of the
remote controls might have been touched
or bumped
during the test,
highlight
Test this code again and press OK (the GUIDE Plus+ system runs
the same set of codes).
&7)..If you don't think the test was interrupted,
highlight No and press OK
(GUIDE Pins+ system tests the next code).
Repeat the previous instructions
until the TV finds the correct cable box
code. Follow the instructions on tile screen.
Note..
[]'the
TV can
l fiud
your
cable
hux
code,
a troabh,
shooting
checklist
appears,
Carqfid{!_
ret&,w
each
checklist
and,/bllow
tbe
inslrllclions
on the
scre(,n
Chapter
1
17
Advertisement
Table of Contents
