Advertisement
Ⅴ. Operation Instruction
Enter Setting Mode
Enter the master code twice (Default value:"12345") to enter setting mode (2 Beeps)
Note: 1. After 60 seconds if no data entered, it will automatically exit the setting mode.
2. The controller will be lockout for 60 seconds upon 32 consecutive master
codes or invalid PINs attempt.
Exit Setting Mode
Press # to exit setting mode
Add new PINs (In setting mode)
1. Enter the master code twice (2 beeps)
2. Press＊001(slot position ＊001~＊099)
3. Enter 5-digit PINs (1 beep)
4. Repeat, or press "#" to exit setting mode
Relay 1 is controlled by the slot position ＊001~＊049
Relay 2 is controlled by the slot position ＊050~＊099
Note: "00000", "12345" and master code cannot be used for PINs.
Set the Relay Strike Time( In setting mode)
1. Enter the master code twice (2 beeps)
2. Press＊100 (or ＊200)
3. Press 05 (01~99) (1 beep)
Press 05 will set the relay strike to 5 seconds, relay set to toggle mode
4. Press "#" to exit setting mode
In Toggle mode, the relay will switch between N.C. contact and N.O. contact upon enter
PIN once.
Delete PINs (In setting mode)
1. Press ＊006 (e.g. code to delete)
2. Enter the master code twice (2 beeps)
3. Press ＊006
4. Press 00000
5. Press "#" to exit setting mode
Change Master Code (In setting mode)
1. Enter the master code twice (2 beeps)
2. Press ＊000
3. Enter new 5-digit master code (1 beep)
4. Press "#" to exit setting mode
Master Code reset to default value "12345"
1. Insert the jumper into 2-3 (5 beeps)
2. Master Code reset to default value
Warranty
The product is warranted against defects in material and workmanship while used in normal
service for a period of 1 year from the date of sale to the original customer. GEM policy is one
of continual development and improvement; therefore GEM reserves the right to change
specifications without notice.
Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG101 Ver. D Publish:2009.12.24
Page: 3/ 3
Advertisement
