Table of Contents
Advertisement
TV GUIDE
PLUS+ CONTROLLER
The TV GUIDE Plus+* controller
allows direct control of a cable
box and VCR using a pair of IR (infrared)
controllers.
Plug the TV GUIDE Plus+ controller
into the VCR CONTROL
.jack on the back of the TV.
Affix the IR controllers
directly over the IR remote sensors on
your cable box and VCR.
Back of TV
Cable Box
II
VCR
Connect IR controllers
to the infrared
remote
sensors on your cable box and VCR
STEP 3
Plug in the TV.
Plug the end into the wall outlet,
matching
the wide blade of
the plug with the wide slot in the outlet.
Be sure to insert the
plug completely.
* GUIDE Plus+ is a trademark
of Gemstar Development
Corporation.
TV GUIDE is a trademark
of TV Guide Financial, Inc.
Locating
the IR (infrared)
Remote Control Sensor on
Your Cable Box or VCR
The IR controllers must be affixed
directly over the IR remote sensors on
your cable box or VCR.
Some cable boxes and VCRs label the
IR sensors; others do not. If the
sensors are labeled, affix the IR
controllers directly over them.
I
IR Remote Sensor
For those that do not label the IR
sensor, you need to use the cable box
or VCR's remote to locate the sensor
before affixing the IR controllers.
1. Hold the remote control so that it
is touching the front of the cable
box or VCR.
2.
Slowly move the remote over the
front of the cable box or VCR
while pressing the remote's
POWER button on and off
3. When the cable box or VCR turns
off or on, you've located the
sensor.
You should test the IR controllers
after setting up the TV GUIDE Plus+
system. Temporarily attach the IR
controllers with clear tape to the
spots where you think the sensors
are located. After determining
that
the controllers are working correctly,
affix them permanently.
5
Advertisement
Table of Contents
