Advertisement
Can't select certain channel
Noisy stereo reception
No picture, no sound but power light
is on
Sound okay, picture poor
Picture okay, sound poor
No stereo on known stereo station
Can't get two channels
in Pix-in-Pix
No picture while using Pix-in-Pix,
with S-VHS VCR or camcorder
Small picture does not have color.
Remote no longer controls cable box,
] •
VCR or audio equipment
l
48
• Channel
may not be in Channel Memory.
Try pressing
number buttons.
• If using VCR, check to make sure TV/VCR switch on VCR is in correct
position.
• To select cable channels
100 thru 128, press number
button 1 until l--
appears.
Then press other two number buttons.
CABLE/AIR
function must
be in CABLE mode to select channels
higher than 69.
• Channel may be locked-out
with Parental
Control feature.
May be a weak station.
Change STEREO/SAP
function
to MONO
setting
instead of STEREO.
• Maybe someone changed
CABLE/AIR
function to wrong position.
• Maybe a vacant channel is tuned.
• For Channels
90, 91, and 92, make sure the component
connected
to those
INPUT jacks is turned on in order to see the picture.
• If watching VCR (connected
only through antenna input), make sure TV is
tuned to channel 3 or 4-same
as CH3/CH4
switch on VCR.
Also check to
make sure TV/VCR switch on VCR is in correct position.
• Check antenna connections.
• Try adjusting
SHARPNESS
function
to improve weak signals.
• Try another channel.
• Try adjusting
VOLUME, BASS, and TREBLE controls.
• If station is sending stereo, try changing
STEREO/SAP
function
to MONO
setting for clearer sound.
• Try adjusting
SRS (O) controls
to turn SRS (0)
offor on.
Make sure STEREO/SAP
function
is in STEREO
mode.
• One channel must come thru ANTA
or B jack and the other channel
must
come thru the INPUT 1 or 2 jacks.
• If using the VCR1 or VCR2 button, make sure it is programmed
to select the
proper video input channel as described
on page 26.
• If using an S-VHS component,
make sure its regular VIDEO cable is
connected
to INPUT I VIDEO jack on the TV.
• If using a VCR, make sure theAUDIO
and VIDEO OUT jacks on the VCR
are connected
to the TV's AUDIO
and VIDEO IN jacks.
If you have an S-VHS VCR (or camcorder)
connected,
you must also
connect
a cable from the VCR s VIDEO OUT jack to the TV s corresponding
I
VIDEO IN jack in addition to the S-VHS cable.
The small picture will not have color if the large picture signal does not have
the color burst reference.
All color signals and some black-and-white
signals
are sent with color burst information.
Try changing
channels
of the large
picture.
Try not to press any buttons
on the remote while changing
its batteries.
You
may have to reprogram
the proper code into the remote.
continued
on next page
Advertisement
