Collar Kit (Eck23Cds) - Electrolux Built-InTrim Kits Guide Planning Manual

Planning Information
For new-build installation when installed with Counter-Depth French Door Refrigerator
models E23BC78IPS, E23BC78ISS, E23BC68FPS and E23BC68FSS
Installation Specifications
New-Build Installation – Collar Kit (PN # ECK23CDS) is designed for
built-in installation with Counter-Depth French Door Refrigerator models
E23BC78IPS, E23BC78ISS, E23BC68JPS and E23BC68JSS.
To use Collar Kit (PN # ECK23CDS), an enclosure is required around
Counter-Depth French Door Refrigerator having an opening of 70-1/4" H x
36-1/8" W with minimum cabinet side panels of 24-1/2" D x 1/2" W.
Minimum 24-1/2" depth requires recessed electrical outlet and water line.
Add maximum of 1/4" to 70-1/4" opening height when installed with
frameless-style overhead cabinets, for door opening clearance.
Cabinet or soffit above unit must extend out to same depth as side panels.
To provide additional clearance for overhead cabinet doors when in open
position, allow 1" from underside of cabinet to bottom of cabinet door.
A minimum width of 36-1/8" is required for refrigerator install ation with
an additional 1/2" or 3/4" added for each side panel.
If 1/2" side panels are used, then side trim piece and panel will be even.
If 3/4" side panels are used, then 1/4" of side panel will extend beyond collar
trim and must be finished.
For detailed Collar Kit installation, refer to instructions packed with kit or on web.
For detailed Counter-Depth French Door Refrigerator installation, refer to
model-specific product page and installation guide on web.
Note: For planning purposes only. Refer to product information
on the web at electroluxicon.com for detailed installation instructions.
Specifications subject to change.
Collar Kit
(ECK23CDS)
13