Advertisement
OPERATING
INSTRUCTIONS
WARNING. Always disconnect
your vacuum cleaner from the
mains supply before maintaining
and or assembling it.
Before you can start using your vacuum
cleaner you must attach the hose (9) and
accessories. Always remove the plug from
the mains supply before fitting or removing
accessories!
1 Insert the hose (9) into the suction inlet
(1) and push until it clicks into position.
To remove the hose (9) press the two
buttons on the end of the hose (9). See
fig. 1.
2 Fit the telescopic tube (10) and which
ever other accessory is required to the
hose (9). See fig. 2.
3 Press down on the release button on the
outer tube and slide the inner tube out to
adjust the length of the telescopic tube
(10). See fig. 3.
NOTE: The dual purpose floor nozzle (11)
has two settings. Each can be selected by
using the foot-operated switch on the left
hand side of the nozzle. See fig.4.
(A) When cleaning hard floors, the
(B) When cleaning carpets, the bristles
4 The combination crevice nozzle/brush
(12) can be used for crevices, corners,
baseboards and between cushions. See
fig. 5.
Fig. 1
5 The upholstery nozzle (13) is used for
upholstered furniture. See fig. 6.
7 Before switching your vacuum cleaner
Fig. 2
on, unwind the cable and insert the plug
into the wall socket. The yellow mark on
the cable shows the ideal length. Don't
unwind the cable beyond the red mark.
See fig. 7.
Fig. 3
4
bristles should be in the extended
position.
should be in the retracted position.
Yellow
Red
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Advertisement
