Problem Solving - Electrolux 300 Series Owner's Manual

PROBLEM SOLVING

NOTE: Turn OFF the power switch and unplug the electrical cord before servicing.
PROBLEM
Appliance won't
start
Appliance won't
make steam
Appliance leaves
water on the floor
Appliance leaves a
whitish halo on
vinyl floor
General questions
CAUSE
Electric plug
Power switch not
turned "ON"
No water in tank
No water in tank
Floorcloth is too wet
Appliance did not
remain flat on
surface while turned
on.
Left in one spot too
long
Assembly or related
accessories
SOLUTION
Push plug securely into
outlet.
Try another outlet.
Check circuit breaker.
Make sure power switch is
"ON."
Check the tank for water.
Check the tank for water.
Change floorcloth.
If wood floor, dry the floor
before proceeding.
Too much water in tank. Do
not overfill.
Turn off, unplug from
electrical outlet, change
floorcloth and reheat
appliance.
Remove with a few drops of
vinegar.
If above step doesn't
remove halo, then reheat
area for one minute and
discoloration will be
removed. Do not overheat
area.
For any advice on your
cleaner, please refer to your
local telephone directory for
your nearest Electrolux
service agent. If you reside
in the UK you may contact
the Customer Care line
08706 055055.