Connect To Wireless Access Point; Using Edimax Utility - Edimax Draft 2.0-N User Manual

2-2 Connect to Wireless Access Point

There are two ways you can configure your wireless network card to connect to wireless access point: using the
Ralink configuration utility which comes with wireless card driver, and using built-in windows zero configuration
utility.
2-2-1

Using Edimax Utility

Please follow the following instructions to use Edimax configuration utility to connect to wireless access point.
1. Right-click the Edimax configuration utility icon located at lower-right corner of computer desktop, then click
'Launch Config Utilities'.
2. Configuration utility will scan for all wireless access points automatically. Scan results will be displayed here,
please check if the wireless access point with the SSID (the name of wireless access point) you preferred is
shown here.
If the wireless access point you wish to connect does not show here, please click 'Rescan' to try again, until
the one you preferred is displayed. You may have to click 'Rescan' for more than two times before you can
see the access point you wish to use here sometimes.
If you still can not see the access point you wish to use after clicking 'Rescan' for more than five times,
please move your computer closer to the location where the wireless access point is, or see instructions in
chapter 4-2 'Troubleshooting'.
- 11 -