Yamaha RX-V671 Owner's Manual page 6

Setup menu items
Speaker
Auto Setup
Power Amp Assign
Manual Setup
Front
Center
Surround
Surround Back
Configuration
Front Presence
Subwoofer
Extra Bass
Bass Cross Over
Distance
Level
PEQ Select
Parametric EQ
PEQ Data Copy
Test Tone
Lipsync
Dynamic Range
Sound Max Volume
Initial Volume
Adaptive DSP Level
Analog to Analog Conversion
Video
Processing
HDMI Control
HDMI Audio Output
Standby Through
IP Address
Network Network Standby
MAC Address Filter
Optimizes the speaker settings automatically (YPAO).
Selects a speaker system.
Selects the size of the front speakers.
Selects whether or not a center speaker is connected and its size.
Selects whether or not surround speakers are connected and its size.
Selects whether or not surround back speakers are connected and its size.
Selects whether or not presence speakers are connected.
Selects whether or not a subwoofer is connected and its phase.
Sets the speakers to produce the front channel low-frequency components.
Sets the lower limit of low-frequency component produced from speakers of which the size is set to "Small".
Sets the distance between each speaker and listening position.
Adjusts the volume of each speaker.
Selects a type of equalizer to be used.
Copies the parametric equalizer values acquired with "Auto Setup" to the "Manual" fields for fine adjustment.
Enables/disabled the test tone output.
Adjusts the delay between video and audio output.
Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and DTS signals) playback.
Sets the maximum volume so that sound is not too loud.
Sets the initial volume for when this receiver is turned on.
Selects whether to automatically adjust the CINEMA DSP effect level in conjunction with volume adjustments.
Enables/disables the video conversion between the analog video jacks.
Enables/disables the video signal processing (resolution and aspect ratio).
Enables/disables HDMI Control. You can also configure the relevant settings (ARC, TV audio input, etc).
Selects a device to output audio (input through HDMI jacks).
Select whether to output videos/audio (input through HDMI jacks) to the TV when this unit is in standby mode.
Configures the network parameters (IP address, etc).
Selects whether or not to turn on this unit by the command from other network devices.
Sets the MAC address filter to limit access to this unit from other network devices.
33
9O
9O
9O
9O
91
91
91
91
91
91
92
92
92
92
93
93
93
93
93
94
94
95
95
96
96
96
96
En 88