Whirlpool Duet Sport WGD8410SW1 Use & Care Manual page 13

You canchange y ourdoor s wing f romaright-side opening toa
left-side o pening, if desired.
1. Place atowel orsoft c lothontopofthedryer o rworkspace
toprotect thesurface.
Remove t hedoorassembly
1. Remove the4screws t hathold thedoor h inge onthefront
panel ofthedryer.
2,
3.
A. Dryer front panel
B. Door assembly
Lay the door assembly on a flat, protected surface with the
inside (inner door assembly) facing up.
Remove the 6 Phillips head screws to release the outer door
assembly from the inner door assembly, as indicated below.
See illustration. It is important that you remove only the
6 indicated screws.
_J
4. Lift the inner door assembly off the outer door assembly.
5. Disengage locking tabs by rotating inner ring clockwise. See
illustration.
Reverse hinge
1. Use a small flat-blade screwdriver to remove 2 plug strips
from the inner door. Slide the head of the screwdriver under
the plugs, being certain not to scratch the inner door surface.
Lift up.
2,
3,
A. Door hinge
B. Plug strips
C. Hinge cover
Remove the 4 screws that attach to the inner door hinge and
move the hinge to the other side. Reinstall the 4 screws.
A. Door hinge
4. Reinstall plug strips on opposite side of the inner door.
5. Check for fingerprints on the glass. Clean glass if necessary.
6. Place the inner door assembly inside the outer door
assembly. To fit correctly, the inner door assembly edge fits
completely inside the outer door assembly edge.
A. Inner ring
B. Outer ring
6. Turn inner ring 180 ° and lock tabs into place.
13