Dryer Use - Whirlpool Duet GGW9250PT3 Use & Care Manual

DRYER USE
Status Control On
O Se,sing 0
Heavy Duty_
0 Wet Normal_
0 Da_,,p _ OMoro Bulky.d_,/
o.oo., .... \ o I,e,,,, IF41
OW, lnkleShi_/d \0 Delicate*k_
Dryness
0 ControlLocked \ Level "_
C----qE,,im ,od
/I "ll'r,_dDry ...'-_ I P ....
/
0_/
Less[
"l l Cancel
_/.Touc_ Up
T'me k.J/ l/._ _
"_,.'. Q,ic_ Dry I \j
0 H_gh
0
Medium
0 Low 0 Louder
0
Extra Low 0 Softer
0 On 0 Air Only 0 Off
0 0 0
Wrinkle Shield Temperature End Of Cycle Signal
(Manuel Cyc}esvrdy) Hold for3 Seconds _o
iock / Uplock C_nttol
J
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Do not dry anything that has ever had anything
flammable on it (even after washing).
Failure to follow these instructions can result in death,
explosion, or fire.
3. Rotate the dial to select either an Automatic or Manual Cycle
then press the CONTROL ON button, The preset settings and
drying time for the cycle chosen will be displayed.
To use an Automatic Cycle
Point the dial to an Automatic Cycle.
Select DRYNESS LEVEL to adjust how dry you want the
load to be. The time displayed is an estimated length of
the cycle based on the Dryness Level selected, As the
cycle runs, the control senses the dryness of the load and
adjusts the time automatically for the selected Dryness
Level.
0 More
0
O Lees
Fire Hazard
No washer can completely remove oil.
Do not dry anything that has ever had any type of oil on
it (including cooking oils).
items containing foam, rubber, or plastic must be dried
on a clothesline or by using an Air Cycle.
Failure to follow these instructions can result in death
or fire.
The following is a guide to starting your dryer. Please refer to
specific sections of this manual for more detailed information.
1. Clean lint screen before or after each cycle. See "Cleaning
the Lint Screen."
2. Place laundry into dryer and shut door. See "Loading."
©
Dryness
Level
NOTE: Time is not adjustable for Automatic Cycles. Pressing
the More Time or Less Time buttons will cause a triple beep,
indicating that the time cannot be changed.
• Press the WRINKLE SHIELD
TM
feature button if this
option is desired.
• Press the END OF CYCLE SIGNAL button to set signal
volume to desired level.
• Press (and hold) HOLD TO START button until dryer starts
(about 1 second).
Once an Automatic cycle has started, the WRINKLE
SHIELD
TM
feature and the End of Cycle Signal level can be
adjusted. Press the PAUSE/CANCEL key twice to stop the
dryer and clear the settings, allowing you to select another
cycle and Dryness Level.
13