Cycle Guide - Whirlpool WED94HEAC0 Use & Care Manual

CYCLE GUIDE -- MANUAL CYCLES
Settings and options shown in bold are default settings for that cycle.
Not all features and cycles are available on all models.
Not all settings and options are available on each cycle.
Selecting the Drying Temperature
A High heat setting may be used for drying heavyweight items such as towels and work clothes.
A Low to Medium heat setting may be used for drying medium-weight items such as sheets, blouses, dresses, underwear,
permanent press fabrics, and some knits.
Use a no heat (air dry) setting for foam, rubber, plastic, or heat-sensitive fabrics.
Line dry bonded or laminated fabrics.
NOTE: If you have questions about drying temperatures for various loads, refer to the care label directions.
iii !i ii/i:// ii !i ii i i:i: ilil !(
Items to dry: Cycle:
Small loads and Quick Dry
sportswear
Any load Timed Dry
NOTE: Select Air
Only to dry foam,
rubber, plastic, or
heat-sensitive
fabrics.
Drying
Temperature:
High
Medium
Low
Extra Low
Air Only
High
Medium
Low
Extra Low
Air Only
Default
Time:
13
40
Ava,able
Options:
Wrinkle Shield 'Mr
Wrinkle Shield 'Mr
Cycle Details:
For small loads of 3-4 items.
Use to dry items to a damp level for items that do
not require an entire drying cycle. Select a drying
temperature based on the type of fabrics in your
load. If you are unsure of the temperature to select
for a load, select the lower setting rather than the
higher setting.
You may select the "With Steam" setting to add a short steam cycle after 60 minutes. This is available only with High and Medium Drying
Temperature settings.
CYCLE GUIDE- STEAM CYCLE
Settings and options shown in bold are default settings for that cycle.
Not all settings and options are available on each cycle.
Steam cycles are designed for use with dry loads to loosen wrinkles, reduce odors, and refresh fabrics.
Ava,a
! ! I I I |
IShirts, blouses, ISteam RefreshI High I 22 Wrinkle Shielder I _ Use to reduce odors and light wrinkles. |
Iandslacks ! I Med,um _ StaticReduce I_ Donotadddryersheets.
/
t Youmay select the "With Steam" setting to add a short steam cycle after 60 minutes. This is available only with High and Medium Drying
Temperature settings.
Load Size Recommendations
For best results, follow the load size recommendations noted
for each cycle.
Q mall load: Fill the dryer drum with 3-4 items,
not more than 1/4 full.
_ Medium load: Fill the dryer drum up to about 1/2 full.
Large load: Fill the dryer drum up to about 3/4 full.
Do not overload. Items need to tumble freely.