Table of Contents
Advertisement
ce
P
ucSos
Ice maker runs but produces
no ice
•
Is the control set to ON? Be sure that the control is set to
ON.
•
Is the water supply connected?
Make sure the water supply
is properly connected and turned on.
•
Is the drain cap securely in place? If the drain cap is loose,
water will empty from the water pan, and you will have either
thin ice or no ice. Tighten the drain cap.
•
Is there debris in the drain tube? Clean the drain tube.
•
Is there a kink in the drain line? Be sure that there are no
•
kinks in the line.
•
Is the off light flashing
on and off continually?
Call for
•
service.
Ice maker runs but produces very little ice
•
Is the room temperature
hotter than normal? Room
temperatures
of more than 90°F (32°C) will normally reduce
ice production.
Electrical
Shock Hazard
Disconnect
power before servicing.
Replace al parts and panels before operating.
Failure to do so can result in death or electrical
shock.
Is the condenser dirty? Dirt or lint may be blocking the
airflow through the condenser. See "Condenser."
Is there scale buildup in the ice maker? If there is white
scale buildup in the ice maker's water or freezing system, you
should clean the ice maker. See "Interior Components"
in the
"Cleaning" section.
Is the drain cap securely in place? If the drain cap is loose,
water will empty from the water pan, and you will have either
thin ice or no ice. Tighten the drain cap if it is loose.
Grid is not cutting ice sheets
Is the cutter grid securely
in place? Check the cutter grid
harness plug to make sure the connection is intact. See
"Interior Components"
section of "Cleaning" for instructions
on cutter grid removal.
Off taste, odor or gray color in the ice
•
Is there unusually high mineral content
in the water
supply? The water may need to be filtered or treated.
Is there mineral scale buildup? Clean your ice maker. See
"Ice Maker System" in the "Cleaning" section.
Are there food items stored in the ice bin? Do not store any
foods in the ice bin.
Were all the packaging
materials removed? Make sure that
all packaging
materials were removed at the time of
installation.
Thin, soft or clumps of ice
•
Is there unusually high mineral content
in the water
supply? The water may need to be filtered or treated.
Is there mineral scale buildup? Clean your ice maker. See
"Ice Maker System" in the "Cleaning" section.
Are there clumps
of ice in the bin? If ice is not used
regularly it will melt and form clumps. Break the clumps with
the ice scoop provided.
Pluynbl[y_ I F _ii .....[_".,
Excessive Weight Hazard
Use two or more people to move and install ice maker.
Failure to do so can result in back or other injury.
•
Is the drain hose aligned over the drain? Move the ice
maker to align the drain. See "Water Supply Connection."
NOTE: Service technicians can not repair plumbing problems
outside of the ice maker. Call a licensed, qualified plumber.
14
Advertisement
Table of Contents
