Weed Eater XT 600 Instruction Manual page 7

SWEEPING - The fanning action of the rotat-
ing line can be used for a quick and easy
clean up. Keep the Ih_e parallel to and above
the surfaces beh_g swept and move the tool
from side to side.
_i_._ Sweeping
_'WARNING:
Disconnect the spark
plug before performing mah_tenance except
for carburetor adjustments.
CHECK FOR LOOSE
FASTENERS AND PARTS
• Spark Plug Boot
• Air Filter
• Housing Screws
• Assist Handle Screw
• Debris Shield
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for re-
placement of damaged or worn parts.
• ON/STOP Switch - Ensure ON/STOP
switch functions properly by pushing and
releash_g the switch. Make sure engine
stops. Wait 5 seconds before attempting to
restart unit to ailow switch to reset. Restart
engh_e and continue.
• Fuel Tank - Disconth3ue use of unit if fuel
tank shows signs of damage or leaks.
• Debris Shield - Discontinue use of unit if
debris shield is damaged.
INSPECT AND CLEAN UNIT AND DE-
CALS
• After each use, inspect complete unit for
loose or damaged parts. Clean the unit and
decals using a damp cloth with a mild deter-
gent.
• Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engh_e perform-
ance and h_creases fuel consumption and
harmful emissions. Always clean after every
5 hours of operation.
1. Clean the cover and the area around it to
keep dirt from falling into the carburetor
chamber when the cover is removed.
2. Remove parts as illustrated.
NOTE: To avoid creating a fire hazard or
producing harmful evaporative emissions, do
not clean filter in gasoline or other flammable
solvent.
3. Wash the filter in soap and water.
4. Allow filter to dry.
5. Add a few drops of oil to the filter;
squeeze the filter to distribute oil.
6. Replace parts.
_ _Filter
._'_ '_..'_. Screws
Air Filter Cover
REPLACE SPARK PLUG
Replace the spark plug each year to ensure
the engine starts easier and runs better. Set
spark plug gap at 0.025 in. Ignition timing is
fixed and nonadjustable.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder and
discard.
3. Replace with Champion RCJ-6Y spark
plug and tighten securely with a 3/4 inch
socket wrench.
4. Reinstallthe spark plug boot.
REPLACING THE LINE
1. Remove spool by firmly pulling on tap
button.
2. Clean entire surface of hub and spool.
3. Replace with a pre-wound spool, or cut two
leng'd_s of 12-1/2 feet of 0.080" (2 mm) di-
ameter Weed Eater _ brand line.
&WARNING:
Never use wire, rope,
string, etc., which can break offand become a
dangerous missile.
4. Insert ends of the iines about 1/2 inch (1
cm) into the small holes on the inside of
spool.
Spool
Small