Table 2-5. Spider Kits; Table 2-6. Spider Installation Required Parts - Garmin GDL 69/69A Installation Manual

Xm satellite radio data link receiver

Hide thumbs Also See for GDL 69/69A:

Activation instructions (36 pages)

Table Of Contents

Table of Contents

2.5.4 Spider Grounding Installation

The Spider Grounding Kit, part of the connector kit, allows shielded cables that go to a backshell to be

terminated to the backshell. Twenty AWG #24 wires are available to splice with the cable shields. The

wires all terminate to a terminal that is fastened to the backshell. A single AWG #16 wire provides

ground reference to the terminal, thereby grounding all Spider leads to the aircraft.

Spider Kit terminals are screwed to the backshell using the tapped holes provided.

Reference

Figure 2-7

Spider Kit w/ 21 Conductors: 011-00980-00 (Included in 011-00997-00)

Wire Harness, Backshell Ground, 21 Conductor

Screw, 4-40 x .250, FLHP 100°, SS/P, Nylon

2.5.4.1

Spider Parts List

The following table provides a list of parts needed to install a Spider kit. Most parts for this installation

are included in the Spider installation kits shown in Table 2-5. Some are to be provided by the installer.

The following tables show the list of required parts as well as callouts for the drawings shown in Figure

2-7.

Reference

Figure 2-7

Cast Housing from Garmin Backshell Kit

2, 3, 4, 5

(method optional, see Step 3 below)

Multiple-Conductor Shielded Cable

(2 –conductor demonstrated here)

Strain Relief from Garmin Backshell Kit

Screw, 4-40x.375, PHP, SS/P, w/NYL

GDL 69/69A Installation Manual

190-00355-02