Removing Grasscatcher - Troy-Bilt series 430 Operator's Manual

Fasten the cable to the lower handle with the two
cable ties found on the lower handle. Pull the cable
ties tight and trim off the excess. See Figure 4.
Cable Tie
Post on
Cable
\ /
Figure 4
Attaching Starter Rope
• The rope guide is attached to the right side of upper
handle. Loosen the wing nut which secures the rope
guide. See Figure 5.
• With the spark plug wire disconnected and
grounded, hold the blade control handle against the
upper handle, and pull the starter rope out of the
engine. Release the blade control handle. Slip the
starter rope into the rope guide. Tighten wing nut.
Slip rope into
rope gu_ Wing Nut
Y
Rope
Guide
• Insert frame into grass bag with the black plastic
side on the bottom of bag. See Figure 6.
Insert frame
Frame
Figure 6
• Slip the side openings of the plastic channel on the
bag over the hooks on the grass catcher frame.
Secure bag to the frame by working the six plastic
channels on bag over frame.
• All the plastic channels attach from the outside of
bag. See Figure 7.
Plastic
Channel
Grass Catcher
Figure 7
Attaching GrassCatcher
• Lift the rear discharge door and place the grass
catcher on the pivot rod. Let go of discharge door so
that it rests on the grass catcher. See Figure 8.
Figure 5
Assembling G rassCatcher
NOTE: If your mower's grass catcher has been already
assembled before shipping, proceed to the next
section. If it is unassembled, follow the steps below.
Figure 8
Removing GrassCatcher
• Lift the rear discharge door on the mower, and lift
the grass catcher up.
• Release the rear discharge door.