Table of Contents
Advertisement
INSTALL
HOOD
I Hang hood from (4) mounting screws. Slide hood towards
wall until mounting screws are engaged in narrow end of
(4) keyholes. Tighten mounting screws securely. A long
screwdriver works best.
4 Install (2) PAR20, 50 W Maximum Halogen Bulbs or
(2) R16, 40 W Maximum Incandescent
Bulbs. Purchase
bulbs separately.
PAR20,
50W MAX.
HALOGEN
BULB (2)
-
or-
R16,
40W MAX.
INCANDESCENT
BULB (2)
KEYHOLE (4)
MOUNTING SCREW (4)
2 Replace
bottom cover.
3 Connect
ductwork
to hood. Use duet tape to make joints
secure and air tight.
DUCT
TAPE
5 Replace filters, turn on power at service panel and test for
proper operation.
NON-DUCTED
FILTERS
If hood is to be installed Non-Ducted:
• Attach charcoal filters to the aluminum mesh filters. Be
• Purchase a set of (2) charcoal filters, model KBK-330,
sure that the sides with the blue and yellow stripes are
from your local distributor, retailer or from Sharp (see
facing down (toward the range top).
page 2).
Advertisement
Chapters
Table of Contents
