Hang hood from (4) mounting screws. Slide hood towards
1
wall until mounting screws are engaged in narrow end of
(4) keyholes. Tighten mounting screws securely. A long
screwdriver works best.
Replace bottom cover.
2
Connect ductwork to hood. Use duct tape to make joints
3
secure and air tight.
If hood is to be installed Non-Ducted:
• Purchase a set of (2) charcoal filters, model KBK-330,
from your local distributor, retailer or from Sharp (see
page 2).
Install (2) PAR20, 50 W Maximum Halogen Bulbs or
4
(2) R16, 40 W Maximum Incandescent Bulbs. Purchase
bulbs separately.
Replace filters, turn on power at service panel and test for
5
proper operation.
NON-DUCTED FILTERS
• Attach charcoal filters to the aluminum mesh filters. Be
sure that the sides with the blue and yellow stripes are
facing down (toward the range top).
9
INSTALL HOOD