Memorizing The Channels - Samsung Esa PDP4294LV Owner's Instructions Manual

BNb_-00 /llA-00esa E Z (wa±±de±) 2004.4.30 Z:bb PM Page
Your PDP can memorize and store all of the available channels for both "off-air" (antenna}
and cable channels. After the available channels are memorized, use the CH /", and CH v
buttons to scan through the channels. This eliminates the need to change channels by entering
the channel digits. There are three steps for memorizing channels: selecting a broadcast
source, memorizing the channels (automatic} and adding and deleting channels (manual}.
Before your television can begin memorizing the available channels, you must specify the type of
signal source that is connected to the PDP (i.e., an antenna or a cable system}.
Press the Menu button. Move the joystick up or
down to select "Channel", then press the joystick
to enter.
Ant
Auto Program
Fine Tune '_ O 1.
LNA ,_ Off
O, Scan
_} ; Move Select Menu
2 Move the joystick left or right to select "Ant",
...... IRC".
STD , "HRC" or
o If you are connected to an antenna, leave "Ant"
displayed, if you connected cable, move the
joystick left or right to the display the type of cable
system: "STD", "HRC", or "IRC".
(if you are not sure which type of cable system you
have, contact your cable company}.
: : STD
Auto Program
Fine Tune _ O
LNA _ Off _"
Ch Scan
!i_:i_£ii!i(ii_iii ¸
Move Select Menu
Press the Menu button to exit.
', STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company
to identify the type of cable system that exists in your particular area.
At this point the signal source has been selected. Proceed to "Storing Channels in Memory"
(next page}.
28