Storage - Remington POLE SAW 8FT Manual

CLEANING AND
MAINTENANCE
Continued
STORAGE
9. Gently push on sharpener knob. Saw must be running for chain to sharpen.
Note: Sparks appearing shows sharpener is working (see Figure 25). If no sparks
appear, continue to adjust sharpener one click at a time. After each click, press
sharpener knob until light flow of sparks appears.
Figure 25 - Sharpening Fast Sharp Chain
After several sharpenings, you must turn sharpener knob more to bring stone into
.osition.
Replacing Saw Chain
Replace chain when cutters are too worn to sharpen or when chain breaks. Only use
replacement chain noted in this manual. Always include new drive sprocket when
replacing chain. This will maintain proper driving of chain. Note: For proper chain
and drive sprocket, see Replacement Parts and Accessories. page 28.
If storing saw for more than 30 days, follow steps below.
1. Drain oil tank.
2. Remove and clean guide bar and chain. Clean guide bar and chain by soaking in
petroleum based solvent or mild soap and water mixture.
3. Dry guide bar and chain.
4. Place chain in container filled with oil. This will prevent rust.
5. Wipe a thin coating ofoil over surface of guide bar.
6. Wipe off outside of saw body. Do this with soft cloth dampened with a mild
soap and water mixture.
7. Store chain saw
• in a high or locked place, out of children's reach
• in a dry place
• in a carrying case or with scabbard over guide bar
m
097017