Table of Contents
Advertisement
7. Adjust PICTURE TILT switches if necessary. *
Certain RCA TV models have
tube. The effects of
geomagnetism (Earth's
o_
magnetic field) may cause the
Pou_r_
s'm_,_
picture to tilt slightly. The
POLAR/TY and STRENGTH
switches on the back of the "IV
let you compensate for this
Pu._
CORRECTION
etfect. If the picture appears
_tted, follow these steps to improve it.
• Make sure the STRENGTH switch is in the OFF position
as the diagram shows.
• Move the STRENGTH switch to the LOW position.
If this
improves the tilt but it is still not satisfactory, move the
STRENGTH switch to the HIGH position. This should
correct the situation. If moving the STRENGTH switch
makes the tilt worse, go to the next step.
• Change the position of the POLARITY switch. If this
improves the tilt but it is still not satisfactory, move the
STRENGTH switch to the HIGH position. This should
correct the situation.
You may need to reset the POLARITY and STRENGTH
switches if the TV is moved or repositioned in the room,
especially if the TV will be facing a different direction.
9.
Review
menus.
1. To see the video menu, repeatedly
press MENU button to select
VIDEO MENU and then press +.
Repeatedly press MENU to select
desired function and then press +
or - to adjust it. Details are on
page 10.
2. To see the audio menu repeatedly press MENU to select
the AUDIO MENU and then press + or- to adjust it.
Details begin on page 11.
8. Set the clock.
1. Repeatedly press the MENU button to select the SETUP
MENU and then press +. Press MENU repeatedly again
to select the CLOCKSET
display.
2. Press and hold the - button to select the correct hour
(including
AM or PM).
Press and hold the + button to
select the correct minute.
The correct time will now
appear on the screen whenever
you change channels
or
press the TV or DISPLAY
button.
Note:
If power is interrupted
for an extended time, you will
need to reset the clock.
* Select models only.
3. To see the setup menu, repeatedly press MENU to select
SETUP MENU and then press +. Repeatedly press
MENU to select desired function and then press + or - to
adjust it. Details begin on page 13.
Advertisement
Table of Contents
