Advertisement
Now that you've chosen a stereo location,
it's time to hook
it up.
SPEAKERS
Each speaker has its own connection terminals on the back
of the system, so connect the wires from each speaker to
oneset
of terminals.
When connecting the speakers, make
sure that the bare end of each wire makes contact
with the
metal grips inside the terminal.
For Each Speaker:
1.
Press down on the tab to open the red terminal
and
insert the red wire (+) into the red terminal.
2.
Press down on the tab to open the black terminal
and
insert the black wire (-) into the black terminal.
ANTENNAS
The AM and FM wire antennas connect to the FM ANTENNA
terminals
and AM terminal
on the system's back panel, and
must be connected for clear reception.
Connect the antenna
wires the same way you connect the speakers.
After connecting the antennas, extend them to their full
length; then you can adjust their position for better
reception
when you are listening to the radio.
AC POWER
Plug the power cord into an AC power outlet that accepts
the polarized
plug (one blade wider than the other).
Notice that the Standby Indicator Light comes on to let you
know that the system is plugged in and ready to use. This
light stays on as long as the stereo is plugged in, so that
you can use the remote control to turn on and operate the
system.
HEADPHONES
To listen to your stereo with headphones
(not included),
use
the 1/4" PHONES jack on the front of the system.
WARNING:
1
Be sure to follow these instructions
carefully; the system can be damaged
if speakers are improperly
connected.
RED
BLACK
Speaker Hookup
RED
BLACK
Antenna
Hookup
Have
a Blast--Just
Not on Your
Eardrums
Make sure that you turn down the stereo
before you put on the headphones; then
increase the volume to the desired level
after they are in place.
3
Advertisement
