Table of Contents
Advertisement
Thingsto Consider
Before You Connect
Protect
Against
Power Surges
Connect all comporlents
before you plug any of their power colds into the wall outlet.
Turn off the TV and/or component
before you connect or disconnect
any cables.
®
Make sure all antennas and cables are properly grounded.
Refer to the Important
Safety Instructions
packed separately=
Protect
Components
from
Overheating
o
Don't block ventilation
holes on any of the components,
Arrange the components
so that air can
circulate
freely,
*
Don't stack components.
®
If you place components
[n a stand, make smeyou
allow adequate ventilation.
o
If you connect an audio rece[vel or amplifier,
place it on the top shelf so the heated air from it won't
flow around other components.
Position
Cables Properly
to Avoid
Audio
interference
o
Insert each cable firmly into the designated jack.
o
If you place components
above the TV, route all cables down the side of the back of the TVinstead
of straight
down the middle of the IV.
o
If your anterma uses 300-ohm
twin lead cables, do not coil the cables. Also, keep the twin lead
cables away from audio/video
cables.
mmportant
Stand
and Base Safety
information
Choose the location for your TV carefully. Place the IV on a stand or base that is of adequate size and
strength to prevent the IV from being accidentally
tipped over, pushed off, or pulled off. This could
cause personal injury and/or damage the IV. Refer to the Important
Safety Instructions
packed
separately.
Use indirect
Light
Don't place the IV where sunlight ol room lighting
will be dheeted toward the screen. Use soft or
indirect
lighting.
Cables Needed
to Connect
Components
to Your TV
The pictures below show the cables needed fol the cormeet[ons represented in this book.
Coaxial cable
S-Video cable
Audio/Video
cables
Chapter 1
Graphics contoined
within this publie_ltion
_lre for representotion
only
3
Advertisement
Table of Contents
