Table of Contents
Advertisement
UsiH9 the Remote CoHtroll
Using Automatic Code Search
The following
instructions
can be used to program the remote to operate your
components,
if you want to stop the automatic
code search without
programming
any of your components,
press CLEAR until the indicator on the remote turns off.
I.
Turn on the component
you want to operate (VCR or DVD player)
2.
Press and hold the component
button
you want to program {VCR, DVD, or
VPORT). While holding the component
button,
press and hold ON*OFF until the
indicator
on the remote turns on, then release both buttons.
3. Point the remote at the component. Press and release PLAY, t hen wait S
seconds or until the indicator on the remote stops flashing.
At this point the remote is searching for the correct code to program. If, after 5
seconds, the component you want to operate does not turn off, press PlAY
again to tell the remote to search the next set of codes.
Continue pressing PlAY until the component turns off or you have searched
through all of the codes. There are 20 total sets of codes. If the component
does not turn off after pressing PlAY 20 times, then the remote can't be
programmed to operate that component.
If the component you want to control does turn off:
I.
Pressand releaseRL:VERSE, then wait 2 seconds. Repeatthis step until the
component turns back ON.
2. To finish, pressand hold STOPuntil the indicator on the remote turns off.
Using Direct Entry
I.
Turn on the component
to be programmed.
2.
Look up the brand and code number(s) for the component
on the code list in
this section.
3.
Press and hold the component
button
you want to program on the remote.
4,
Enter the code from the remote
control
code list on the following
pages. If the
indicator
flashes,
you have either entered
an invalid code or the button
isn't
programmable.
S.
Release the component
button.
6.
Point the remote at the component.
Press ONeOFF to see if the component
responds to the command. If it doesn't, try pressing the component
button
and
then ONeOFF again.
*
if you get no response, repeat these steps using the next code listed for your
brand, until the component
responds to the remote commands.
*
If you try all the codes for your component
brand and none work, try the
automatic
code search method. If automatic
code search doesn't find the code,
the remote is not compatible
with your component.
Chapter 2
Graphics contained
within this publication
are for representation
only.
1 1
Advertisement
Table of Contents
