Table of Contents
Advertisement
Sample Connections
The following
are sample connection
scenarios you may encounter
when
connecting
components
to your TV. Note: those components
which offer
an S-Video connection,
such as DVD, VCR or satellite
receivers, must
match their S-Video connection
with their audio INPUT connection.
Cables
You will use the following
types of cables to make your connection:
Coaxial
Cables: Carries the signal from the
antenna or cable directly to the television
or
through
a cable box, as needed by your cable
system.
AudioNideo
Cables: Carries audio and video
from a component
to the TV.
S-Video Cable: Carries video from an S-Video
capable component
which provides best picture
quality.
TV and Stereo VCR
Compared
to the Basic Connection,
using Audio/Video
and
S-Video (if available)
cables will enhance the sound and picture quality
from a component.
Cautions:
Position Cables to Avoid Audio Hum
or Interference
• Insert all cables firmly into jacks.
• Place the audio/video
cables to the
sides of the TV's back panel instead of
straight down the middle.
• Try not to coil any twin-lead cables and
keep them away from the audio/video
cables.
Protect Your Components From
Overheating
• Do not block ventilation
holes in any of
the components• Arrange the
components so that air can circulate
freely•
• Do not stack components.
• Allow adequate ventilation
when
placing your components in a stand•
• Place an amplifier on the top shelf of
the stand so heated air rising from it
will not flow around other
components•
CABLE, CABLE BOX, OR ANTENNA
VCR I
_..
OUT
IN FROM_ANT
OH3
I
1_ 1_ 1_
OUT T O TV
II
I
v'_° R
_
_d
_v,oEo ....
_A_0o %No
I
/
CABLE/
CONTROL
(_
ANTENNA
S VIDEO
I
Please note that models F25625 and
|
F27625 do not include an S-Video jack or
J
Audio Output jacks.
How to View Your VCR
To watch the VCR in this connection,
press TV to put the
remote control
into TV mode, then press WHO,INPUT
to
toggle to the video (VID) inputs.
In the Interactive
Setup section you can program the TV to
automatically
tune to the VlD input channel when you turn
on the VCR.
Most Audio/Video
cables are combined
|
into one cable with three
J
heads on each end.
We show individual
_4Y
--
•
_
RFqht AudFo
([e_Right Audio
(red)
cables in these
sample connections.
_
--
•
Left Audio
(white)
Either may be used,
but you must be sure to
connect Video to Video,
Right to Right and Left to Left.
m
7
Advertisement
Table of Contents
