GE 35GT695FM1 User Manual page 22

Placing Channels.in Memory (Autoprogramming).
Only channels-2-13 appear in the TV's memory when you first turn it on.
The channels available in your area must be programmed into the TV's
memory when you hook up your TV, Using CHANNEL UP and down
allows you to scan through these channels.
You may want t° add or delete a few Channels ff some Stations have weak
signals or were off the air when theTV was programme d. Refer to the Add
or Delete Channels section below.
1,
Place channels in
memory (Autoprogram)
3ontrols Alarm
A. Hook up an antenna, cable or
components before you begin
these steps or you will not be
able to add channels into
memory.
B. Press MENU-PROG repeatedly
to select the Setup Menu and
highlight Autoprogram. This
menu is white.
C. Press MOVE • to highlight
Autoprogram.
D. Press MOVE • to start the TV
adding all active channels into
memory.
E. Wait until the TV has cycled
through all theChannels and
returns to the original C hannel.
2. Add or delete channels
AI
13
13
A. Press MENUopROG repeatedly
to select the Setup menu. This
menu is white.
B. Press MOVE• to highlight
Channel Memory.
C. Press MOVE • to underline the
Channel number.
D. Select the channel number you
want to add or delete with the
number buttons.
E. Press MOVE • to add or delete
a Channel (you will see Stored
on the screen when added and
Erasedwhen deleted).
F. Repeat D•and E for more
channels.
2O