Table of Contents
Advertisement
2.
To finish,
press and hold STOP until the red light on the
remote turns off.
Using
Direct
Entry
1.
Turn on the component
to be programmed.
2.
Look up the brand
and code number(s)
for the component
on the code list on the last page of this section.
3.
Press and hold the button on the remote you want to
program.
4.
Enter the code from the code list.
5.
Release button,
and then press ON.OFF to see if the
component
responds to the remote commands.
If it doesn't,
try pressing the component
button and then ON.OFF again.
6.
If you get no response,
repeat these steps using the next
code listed for your brand, until the component
responds to
the remote commands.
Modes
of Operation
Because this universal remote can
control several different components
(DVD player, VCR, cable box, etc.), it
uses operational modes triggered by
the component buttons. For
example, if you want the remote to
control the TV, you would press the
TV button to put the remote into TV
mode before you could control the
TV.
Using
the Remote
to Control
a Device
Once the remote has been programmed
successfully,
you are
ready to use it to control your devices. To operate the device:
1.
Press the device button (TV, VCR1, VCR2, DVD, or
SAT.CABLE) to set the remote to control the device,
2.
Press ON.OFF to turn the device ON or OFE
3.
Use the remote buttons
that apply to that device,
Front
Panel
If you cannot locate your remote, you can use the front panel of
your TV to operate many of the TV's features.
MENU
Brings up the Main menu. When in the menu system, it
selects highlighted
items, Also returns you to the previous
menu.
CH v
Scans down through
the current channel
list. In the
menu system, it points down to items and adjusts menu
controls.
CH ^
Scans up through
the channel
list. In the menu system, it
points up to items and adjusts menu controls,
VOL -
Decreases the volume.
When in the menu system, VOL
- is used to point left to items and adjust menu controls.
VOL +
Increases the volume.
When in the menu system, VOL +
is used to point right to items and adjust menu controls.
POWER
Turns the TV on and off.
MENU
HV
_
VOL i
VOL +
POWER
1
The front panel above shows a
typical button layout. The exact look
of the buttons may be different from
those on the front of your TV.
The front panel block feature disables
all front panel buttons if Parental
Controls are locked. For more
information,
see Parental Control, in
the Features and Menus section.
k
23
Advertisement
Table of Contents
