Advertisement
5. Connect
antenna
or cable-TV
system.
Most antenna or cable-TV
systems can be connected
as
show here.
Back
olrV
,tl¢l" A
J
/
/
t"_'/
ANTi
Incoming
Cable from Antenna or
(_
Cable-.TV
System
(_wam._
• Details for connecting a home antenna to your TV are on
page 32.
• Details for connecting a cable-TV system to your TV
are on pages 33-34.
• Details for connecting a VCR to your TV are on
pages 37-38.
6.
Attach power cord.
First attach the flat end of the power cord completely into the
connector on the back of your "IV, and then plug the other
end into a wall outlet.
7. Turn on TV, adjust the volume, and select a channel.
• Press the TV button on the
remote to turn on the TV.
When using the remote,
remember to point it at the
front of the TV.
• Press the VOLUME up or
down button to adjust the
volume to a desired level.
• Press the CHANNEL up or
Numb_
Buttons
G_
"rv
:X::I:D
_
C_WNEL
=::_.
Buttons
!_ ._
eaton,
53_"
down button to select the next channel in memory. You can
also press two number buttons to select a channel. To select
a 3-digit cable channel (up to channel 128), press and hold
number button 1 until 1-- appears on the screen. Then press
the other two numbers. Channels 2-13 were programmed
into the channel memory for you at the factory, so pressing
CHANNEL up or down stops at these channels only. When
you start the AutoProgramming
feature (described in step 9),
your set will automatically scan through all channels and
place only the active channels for your area into its channel
memory.
• Details about using the remote are on page 9-13.
8. Converge
Colors
if Necessary.
If you notice colored rings or halos around objects in the
picture, you may need to converge the colors. Over a period
of time, the picture tubes can drift out of alignment due to
normal bumps and vibrations or moving the TV. Details for
converging the colors are on page 15.
MENU
_
_
9. AutoProgram
the TV's
8_t,._
channel
memory.
_ Button /
_
• Button
To start the TV autoprogramming
itself, press the MENU button
' _
-
1
repeatedly to select SETUP MENU
L.._____._
and then press + to display the setup functions. Repeatedly
press MENU again to select the AUTOPROGRAM
function,
and then press +. Details are on page 24.
You can also add and erase channels from memory as desired.
Press MENU repeatedly to select the SETUP MENU, then
press + to display the setup functions.
Press MENU repeatedly to select (highlight) the CHANMEM
function. Select the desired channel number by pressing the
CHANNEL up or down button or by pressing the two
corresponding number buttons.
Then press + to add a channel, or press - to erase a channel.
Details are on page 24.
Advertisement
