Advertisement
Can'tselect c ertain channel
Noisy
stereo reception
No picture, no sound but power light
is on
Sound okay, picture poor
Picture okay, sound poor
• Channel may not be in Channel
Memory.
Try pressing
number buttons.
• If using VCR, check to make sure TV/VCR switch on VCR is in correct
position.
• To select cable channels
100 thru 128, press number button 1 until 1--
appears.
Then press other two number buttons.
CABLE/AIR
function must
be in CABLE mode to select channels
higher than 69.
• Channel may be locked-out
with Parental
Control feature.
May be a weak station.
Change STEREO/SAP
function to MONO
setting
instead of STEREO.
• Maybe someone changed CABLE/AIR
function to wrong position.
• Maybe a vacant channel is tuned.
• For Channels
90, 91, and 92, make sure the component
connected
to those
INPUT jacks is turned on in order to see the picture.
• If watching
VCR (connected
only through antenna input), make sure TV is
tuned to channel 3 or 4-same
as CH3/CH4
switch on VCR.
Also check to
make sure TV/VCR switch on VCR is in correct position.
• Check antenna connections.
• Try adjusting SHARPNESS function to improve weak signals.
No stereo on known stereo station
• Make sure STEREO/SAP
function is in STEREO
mode.
Can't get two channels
in Pix-in-Pix
•
No picture while using Pix-in-Pix,
with S-VHS VCR or camcorder
Small picture does not have color.
Try another channel.
Try adjusting
VOLUME, BASS, and TREBLE controls.
If station is sending stereo, try changing STEREO/SAP
function to MONO
setting for clearer sound.
Try adjusting SRS (O) controls
to turn SRS (O) off or on.
One channel must come thru ANTA
or B jack and the other channel
must
come thru the INPUT 1 or 2 jacks.
• If using the VCR1 or VCR2 button, make sure it is programmed
to select the
proper video input channel as described
on page 26.
• If using an S-VHS component,
make sure its regular VIDEO cable is
connected
to INPUT 1 VIDEO jack on the TV.
• If using a VCR, make sure theAUDIO
and VIDEO OUT jacks on the VCR
are connected
to the TV's AUDIO
and VIDEO IN jacks.
If you have an S-VHS VCR (or camcorder)
connected,
you must _ilso
connect a cable from the VCR's VIDEO OUT jack to the TV's corresponding
VIDEO IN jack in addition
to the S-VHS cable.
The small picture will not have color if the large picture signal does not have
the color burst reference.
All color signals and some black-and-white
signals
are sent with color burst information.
Try changing
channels
of the large
picture.
Remote no longer controls cable box,
VCR or audio equipment
50
! • Try not to press any buttons on the remote while changing
its batteries.
You
!
may have to reprogram
the proper code into the remote.
I
continued
on next page
Advertisement
