RCA VR626HF User Manual page 3

Video cassette recorder
Table of Contents

Advertisement

IMPORTANT
SAFEGUARDS
In addition
to the careful
attention
devoted
to quality
standards
in the mahufacture
of your product,
safety is a major
factor
in the design
of every product.
However,
safety
is your responsibility
too.
This sheet lists important
information
that will help to assure your enjoyment
and proper
use of.the
product
and
accessory equipment.
Please read them carefully
before
operating
and using your product.
Installation
Read and Follow
Instructions--All
the safety and operating
instructions
should be read before the product is
operated.
Follow all operating
instructions.
2
Retain
Instructions--The
safety and
operating
instructions
should be retained
for future
reference.
7
8
4
Heed Warnings--Comply
with all warnings on the
product
and in the operating
instructions.
•Polarization/Grounding--This
product
is equipped
with either a polarized,
non-polarized,
or a grounding
type power
cord plug.
If equipped
with the non-
polarized
type (two blades of identical
size), the
following
does not apply.
• A polarized power plug (two blades,
one wider than the other) will fit into a
power receptacle only one way. This is a
safety feature. DO not defeat it. If you.
are unable to insert the plug fully, try
reversing it, or have an electrician
change the receptacle. If you need an
extension
cord, use only a polarized
extension
cord.
• A grounding type power plug (two
blades and a round pin) will fit only into
a grounding type receptacle with
matching Openings. This is safety feature.
Do not defeat it: You may need an
electrician to install a grounding type
receptacle.
If you need an extension
cord, use only a
grounding
type extension
cord.
Power
Sources---This
product
should be operated
only from the type of power source indicated
on the
product's marking
label. If you are not sure of the type
of power
supply to your home, consult your dealer or
local power
company.
For products intended
to
:
operate
from
battery
power, or other
sources, refer to
the operating
instructions.
Overloading--_o
not overload
wall outlets
or extension
cords as
this can result
in a risk of fire or
electric
shock. Overloaded
AC
outlets,
extension
cords, frayed
power cords, damaged
or cracked
wire insulation,
and broken
plugs
are dangerous.
They may result
in a shock or fire
hazard. Periodically
examine the cord, and if its
appearance
indicates=damage
or deteriorated
9
10
11
Power-Cord
Protection-'-Power-supply
cords should
be routed so that they are not likely to be walked
on
or pinched by items placed
upon or against them. Pay
particular
attention
to cords where they are attached
to plugs, convenience
receptacles
and at the point
where they exit from the product.
Ventilation--Slots
and openings
in the enclosure
are
provided
for ventilation
to ensure
reliable operation
of
the product and to protect it from overheating.
These
openings must not be blocked
or covered. -These
openings should never be blocked by placing the
product on a bed, sofa, rug, or other similar surface
This product should never be placed near or over a
radiator
or heat register,
or another
heat source
(including
amplifiers).
This product should
not be
placed in a built-in installation
such as a bookcase or
equipment
rack unless proper
ventilation
is provided or
the product manufacturer's
instructions have been
followed.
Attachments_Do
not use attachments
unless
recommended
by the product
manufacturer
as they
may cause hazards.
Water
and Moisture--Do
not use this product near
water--for
example,
near a bath tub, wash bow!,
kitchen
sink or laundry tub, in a wet basement,
or near
a swimming
pool and t_he like.
Accessories---Do
not place this product on an
unstable
surface or support. The product may fal!,
causing serious injury to a child or adult as well as
serious damage
to the product.
Any mounting
of the
product should follow the manufacturer's
instructions
and use only a mounting
accessory recommended
by
the manufacturer.
11A A product and cart combination
should
be moved with (:are. Quick
stops, excessive force, a_d uneven
surfaces may cause the i3roduct and
cart combination
to overturn.

Advertisement

Table of Contents
loading

Table of Contents