Table of Contents
Advertisement
Oth r
Inf@r at @n
Scheduled
Watch
or Record doesn't
occur
•
Check Schedule
for timer conflicts. Go to page 44 for instructions.
•
Make sure the wands of the G-LINK cable are placed in front of the remote sensor(s) on the component(s).
•
Make sure your VCR is turned off during the time you've scheduled
to record a program
because
the system turns the VCR on when
it starts recording
(if it's already on when recording
starts, the system will turn it off).
•
Make sure there is a tape in the VCR and that the VCR is connected
properly.
•
Be sure that you set up the VCR in the GUIDE Plus+ Setup menus. If you don't complete
the Cor_iguring.fi_r
a VCR steps
successfully,
the Record option won't be available. Go to p. 18 for detailed instructions.
•
If a cable box is attached
to your TV, make sure you set it up correctly in the GUIDEPIus+ Setup menus. Go to page 16-17 for
detailed
instructions.
The Remote
Control
Doesn't
Work
•
Something
might be between
the remote and the remote sensor on the component.
Make sure there is a clear path.
•
Maybe the remote isn't aimed directly at the component
(TV or VCR) that you're trying to operate.
•
Maybe batteries in remote are weak, dead or installed incorrectly.
Put new batteries in the remote.
•
You might need to drain the remote's
microprocessor:
remove batteries and press the nmnber
1 button for at least 60 seconds.
Release the 1 button,
replace the batteries, and (if necessary)
program
the remote again.
Problems
with
V-Chip/Parental
Controls
The rating limits don't work
•
You must lock the settings. Go to the TVMA1NM£NU (press MENU on your remote), select Parental Controls (press 6 on your
remote), select Lock Parenlal Controls (press 6 on your remote).
I don't
remember
my password
and I want
to unlock the TV
•
If you forget your password,
simultaneously
press anti hold MENU on the television
anti volume down on the remote for 3 seconds.
Nothing appears
on the screen, Parental Controls simply unlock and you can re-enter a password
via Lock Parenlal
Controls.
The V-Chip won't
let me watch
a program
even though
it's not rated as violent.
•
Maybe the movie was given an NR (Not Rated) status. After you block movie ratings, you must set Nil to View separately
in order to
view movies with an NR rating.
48
Advertisement
Table of Contents
