Table of Contents
Advertisement
Startup
3. Turn
on the TV.
A.
B
I urn on the 1 V.
If you used one of the basic hookups, tune the TV
to the channel selected with the CH3 CH4 switch
on back of VCR.
If you used one of the advanced
hookups,
tune the
TV to the TV's video input.
(See TV owner's
manual
for details.)
4. Turn
on the VCR.
A. Press POWER on the remote.
5. Place
channels
in the VCR's
memory.
The first time you turn on the VCR or after a power
interruption,
perform
the AUTO CHANNEL SEARCH
so that your VCR can locate the channels
available
through
your signal type-cable
or antenna.
The
signal type is automatically
selected when you perform
the AUTO CHANNEL SEARCH function.
Also, if you
change the signal type, you will need to perform
AUTO
CHANNEL SEARCH again.
A. Press MENU to display the VCR MAIN MENU on
the TV screen. If this menu does not appear:
• Make sure TV is tuned to same channel as the
CH3 CH4 switch on the back of the VCR or the
TV's video input (refer to TV's manual).
• Press MENU again.
• If you use a basic hookup, check VCR indicator
in display panel - it should be on. Press
TV•VCR to turn it on.
• Check the connections.
B. Press 3 to display the CHANNELS menu.
C. Press 1 to begin AUTO CHANNEL SEARCH.
The VCR automatically
selects CABLE (cable TV)
or ANTENNA.
If you need to change the setting
manually, press 3.
Wait until the channel numbers
stop changing.
This
takes about one to two minutes.
The TV will then tune
to the lowest channel found.
Pressing
CHANNEL up or
down will select only the active channels.
AUTO
CHANNEL
SEARCH
Now
scanning
channel
45
Press
any
key
to
cancel
VCR
MAIN
MENU
1
Timer
Recordings
2
Set
CLock
3
Channels
CHANNELS
1
Auto
Channet
Search
2
AddlRemove
Channels
3
Signal
Type:
CABLE
0
Exit
8
Advertisement
Table of Contents
