Table of Contents
Advertisement
Playback
Playback
Operation
I.
Set the CH3/CH4
switch
on the
RF output adapter
to channel
Clt3
or CH4.
2.
Turn on the TV, and tune it to the
same channel
you selected
v,'ith the
RF output
adapter's
CH3/CH4
switch.
3.
Press and hold the small button
on the
CAMERA/OFF/VCR
switch
while you
set it to VCR.
4.
Press PLAY on the camcorder.
• Turn the volume control on the
monitor down all the way to
prevent picture distortion.
• During playback, use the playback
features (s'ee pages 54-55,fin'.fidl
des{'J'iption).
5. Press STOP/E.IECT
on the camcorder
when you are finished.
Viewing What's
Recording
I. Turn on the TV and tune it to channel
3 or 4. Turn the TV's volume down to
prevent a high-pitched
squeal caused
by feedback.
2. Set the Ct13/CH4 switch on the RF
output adapter to the same channel
you selected on the TV.
3.
Press and hold the small button on the
CAMERA/OFF/VCR
switch
while you
set it to CAMERA.
4.
Press • ' " the RE(/PAL,
S£_ •
_ _ button to begin
recording. You can watch what the
camcorder
is seeing (or recording)
on the TV screen.
Normal
TV viewing
For normal
TV viewing,
leave the RF output adapter hooked
up to the TV. Disconnect
the adapter's
plug from the camcorder
or turn the camcorder's
power
off.
Note to Cable
TV Installer
This reminder
is provided
to call your attention
to Article
820-40
of the
National
Electrical
Code (Section
54 of Canadian
Electrical
Code, Part I),
that provides
guidelines
for proper
grounding
and, in particular,
specifies
that the cable
ground
shall he connected
to the grounding
system
of the
building
as close to the point of cable entry as practical.
60
Advertisement
Table of Contents
