Assembly; Operation And Adjustment - ProForm 520 Owner's Manual

ASSEMBLY
The help of a second person is needed. Set the treadmill in a cleared area and remove all packing materials.
Do not dispose of the packing materials until assembly is completed, TOOLS REQUIRED FOR ASSEMBLY: The
7/32" allen wrench _===J included and your own adjustable wrench _ .
1. With the help of a second person, raise the Right Upright (16)
and Left Upright (not shown) to a vertical position.
Align the hole in the lower end of the Right Upright with the hole
in the side of the Frame (45). Insert a 3/8" x 3 1/4" Bolt (20), with
a Flat Washer (19), into the Right Upright and tighten the Bolt
into the Frame. Tighten the Bolt that is already in the Right
Upright.
Attach a Bolt and Washer on the left side in the same manner
(not shown).
19
,
With the help of a second person, rotate the Handrail (7) up as
shown. Insert two Handrail Lock Bolts (1) into the Left and Right
Uprights (2, 16) and tighten the Bolts with the 7/32" Allen
Wrench (91).
2
3. Slide the metal Clothes Clip onto the Pulse Earclip in the indicat-
ed location. The use of the Pulse Earclip is explained in the LED
DISPLAY OPERATION section on page 9.
3 Pulse Earclip_
Clothes__
4. Remove the paper backing from the Wrench Clip (68). Press the
Wrench Clip onto the Frame (45) in the indicated location. Press
the 3116" Allen Wrench (67) into the Wrench Clip.
Make sure that all parts are tightened before using the treadmill.
Note: To protect the floor, a covering should be placed under
the treadmill.
68_-_67
45
OPERATION AND ADJUSTMENT
6
PLUGGING IN THE POWER CORD
This product must be grounded. If it should malfunction or break down, grounding provides a path of least
resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an
equipment-grounding conductor and a grounding plug. Plug the power cord into an appropriate outlet that Is
properly Installed and grounded In accordance with all local codes and ordinances.