Assembly And Operation - ProForm CROSSWALK DUAL Owner's Manual

ASSEMBLY AND OPERATION
The CROSS WALK is delivered in the compactstowaway position. Set
the CROSS WALK in a cleared area and removeall packihg materials.
Make sure thatall parts are included before disposingof Ihe packing
materials. Slidethe LockKnob Washer (78) onto the I.o_kKnob (77).
Raisethe Upright(10) to the verticalpositionand lightenIhe LockKnob
into the Upright.The useof the remaining parts will be describedin
othersectionsof this manual.
_ 10
APPLYING SIUCONE LUBRICANT
To reduce the Friction of thewalking belt and minimizewear, a non-oil-,
non-petroleum-base siliconelubricant mustbe applied to the walking
platform beforethe CROSS WALK is used. WITH THE POWER CORD
UNPLUGGED, lift each side of the walking belt and spray lubricantgen-
erouslyonlo the indicated area. Reapply lubricantafter every ten hours
of use, or wheneverperformance decreases.Lubricantisavailable at
hardware and automotivestores.Uni*Sport
TM
spray is recommended.
PLUGGING IN THE POWER CORD
This product mustbe grounded. If it shouldmalfunction or break down, grounding providesa path of leastresistance
for electriccurrentto reducethe riskof electricshock. This productis equipped with a cord having an equipment-
grounding conductorand a groundingplug. PlugIfle power cord into an appropriate outlet Iflat is properly installed
and grounded in accordancew;th all local codes and ordinances.
A DANGER:
I mproper connectionof the equlpment-grounding conductor can resultin a risk of electricshock.
Check with a qualified electricianor serviceman if you are in doubt as to whether the product is properly grounded. Do
not modify theplug provided with the product--if it will not fit the outlet, have a proper outletinstalledby a qualified
electrician.
This product is for use on a nominal 120-volt circuit, and has a grounding plug as shown in Drawing 1. A temporary
adapter like the adapter shown in Drawing 2 may be used to connectthis plug to a 2-pale receptacleas shown in
Drawing 2 iFa properly grounded outlet is not available. The temporary adapter shouldbe used only until a properly
grounded outlet(Drawing 1) can be installed by a qualified electrician.The green-colored ear, lug, or the like extend-
ing from the adapter must be connected to a permanent ground suchas a properly grounded outletbox cover. When-
ever the adapter is used,it mustbe held in place by a metal screw. Some 2-pole receptacle outlet box covers are not
grounded. Contacta qualified eledrician to determine if Ifle outlet box cover is grounded before using an adapter.
1
Grounded Outlet Box
Grounding Plug
Grounding Pin
Grounded Outlet
Matal Screw
Grounded Outlet Box
Grounding Pin
Grounding Plug
S