Remote Control - RCA P60752 User Manual

The steps below will help you get your TV connected and
working quickly.
1.
Unpack TV and accessories.
Shown here are the accessories thatcame packed with your TV.
Remote Control
Four AAA Batteries for
Remote
Power Cord
1
Caution
Always move TV from either end.The TV could tip
J[fpushed or pulled from the center of the front or back.
Position the TV by rolling the right side close to its final
location then swinging the left side back to its final location.
Never push on the screen.
Install batteries in remote control.
Details are on page 4.
3,,
Position TV in room.
A major benefit of a Projection Color Television is its large
viewing screen. To receive full benefit of the expanded screen
size, placement of the TV in the viewing room is important.
You will see the best picture if you sit directly in front of the
TV about 10-18 feet from the screen. Picture brightness will
decrease if you sit to the extreme left or right of the TV.
During daylight hours, you may also see some reflection on the
screen from exterior light sources. If so, you may wish to use
drapes or screens to reduce reflection or consider a different
placement of the TV.
CAUTION: Inadequate or poor ventilation may cause
overheating, damage, or the risk of fire hazard.
4.
Connect antenna or cable-TV system.
Most antenna or cable-TV systems can be connected as
show here.
Back of TV
, _JJ'"zJ _
Incoming Cable from Antenna or
Cable-TV System
• Details for connecting a home antenna to your TV are on
page 30.
• Details for connecting a cable-TV system to your TV
are on pages 31.
• Details for connecting a VCR to your TV are on
pages 35-36.
5. Attach power cord.
First attach the flat end of the power cord completely into the
connector on the back of your TV, and then plug the other end
into a wall outlet.
6.
Turn on TV, adjust the volume, and select a channel.
• Press the TV button on the
remote to turn on the TV.
When using the remote,
• remember to point it at the ButtonseWUWVEt
front of the TV.
Number-
•
Press the VOL up or down a_on,
button to adjust the volume
to a desired level.
• Press the CHAN up or down
_ Button
VOLUME
Buttons
button to select a channel in memory. You can also press
two number buttons to select a channel. To select a 3-digit
cable channel (up to channel 128), press and hold number
button 1 until 1-- appears on the screen. Then press the other
two numbers. Channels 2-13 were programmed into the
channel memory for you at the factory, so pressing CHAN up
or down stops at these channels only. When you start the
AutoProgramming feature (described below), your set
automatically scans through all channels and place only the
active channels for your area into its channel memory.
Details about using the remote are on page 4-7.
This projection TV is equipped with ventilation openings in
the cabinet back and bottom to allow heat generated during
operation to bereleased. Inadequate air flow to these openings
may result in failures due to overheating, damage to your TV,
and the risk of fire hazard.
When locating and installing your projection television
receiver, read and carefully follow the instructions contained in
the "Installation" section in the enclosed safety pamphlet.
#,
2