Setup And Connection; Dipole Antenna - GE 19GT243 User Manual

Setup and Connection
Step 1: Connect Your TV
Connect the cable from your cable system or off-air antenna to the cable
in-jack on the back of the TV, as shown.
Step 2: Plug In Your TV
Plug the end of the power cord into the wall outlet, matching the wide
blade of the plug with the wide slot in the outlet. Be sure to insert the
plug completely.
Step 3: Put Batteries in the Remote Control
1. Remove the battery compartment cover from the back of the
remote.
2. Insert batteries as shown, matching the + and- ends of each
battery in the compartment.
3. Replace the cover.
Step 4: Turn on the TV
Press the POWER button on the remote or front panel.
Step 5: Auto Channel Search
Perform an Auto Channel Search (described in the Channel menu
section).
Dipole Antenna Connection (Optional)
Follow the steps to connect an indoor antenna (only if you do not
connect an outdoor antenna or a cable-TV system).
Insert the antenna base into the pocketed slot on the back of your set.
Stand at the back of your set with the antenna twin-lead facing you, and
press the base of the antenna into the slot until it locks in place.
Connect the ends of the twin-lead to the Antenna Adapter (not supplied).
Connect the Antenna Adapter to the ANTENNA connector on the back of
the TV.
Later, after you've turned on the TV, adjust the length and position of the
antenna rods for best reception.
• For viewing VHF channels, extend the rods fully.
• For viewing UHF channels, shorten the rods for best reception.
Note: You can purchase a Dipole Antenna and Antenna Adapter
from your local electronics store or the order form on page 11.
Antenna Adapter
(Not Supplied)
ANTENNA, CABLE, CABLE BOX OR VCR
TV (Back Panel)
Dipole Antenna (Not Supplied)
Base
Twin Lead
ANTENNA