Table of Contents
Advertisement
ASSEMBLY
HOW TO SET UP YOUR TRACTOR
CHECK
BATTERY
(See Fig. 2)
•
Lift seat pan to raised position and open battery box
door.
If.this battery is put- into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps,
(See "BAI-rERY"
in CUSTOMER RESPONSIBILITIES
section of this manual for charging instructions).
BATTERY
LABEL
TO ATTACH
NOSE ROLLER
(See Fig. 4)
Positionbrackets, 17/32 x 7/8 x 16 gauge washers, and
nose toiler between deck mounting brackets as shown.
Be sure to position brackets on correct side, as shown.
•
Instal[ 3/8-16 x 1 hex bolts and 3/8-16 lock nuts as
shown. Tighten hardware securely.
NOTE: Be sure bracket tabs are positioned in tab holes in
deck brackets.
TAB
"A"BRACKETTAB
HEX
"B"
/
LOCK NUT
BRACKET
TAB
WASHER
FIG. 4
FIG. 2
INSTALL
SEAT
(See Fig. 3)
Adjust seat before tightening adjustment bolt.
•
Remove cardboard packing on seat pan.
Place seat on seat pan and assemble shoulder bolt.
Tighten shoulder bolt securely.
Assemble adjustment bolt, Iockwasher and flatwasher
loosely. Do not tighten.
•
Lower seat into operating position and sit on seat.
•
Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way
down.
•
Get off seat without moving itsadjusted position.
•
Raise seat and tighten adjustment bolt securely.
SEAT
SEAT PAN
BOLT
ADJUSTMENT
KNOB
LARGEFLAT
WASHER
FIG. 3
CHECK
TIRE
PRESSURE
The fires on your tractor were overinflated at the factory for
shipping purposes. Correct tire pressure is important for
best cutting performance.
•
Reduce tire pressure to PSI shown in "PRODUCT
SPECIFICATIONS _ on page 3 of this manual.
CHECK
DECK
LEVELNESS
For best cutting results, mower housing should be properly
leveled.
See "TO LEVEL MOWER
HOUSING"
in the
Service and Adjustments section of this manual.
CHECK
FOR
PROPER
POSITION
OF
ALL
BELTS
See the figures that are shown for replacing motion and
mower blade drive belts in the Service and Adjustments
section of this manual.
Verify that the belts are routed
correctly.
CHECK
BRAKE
SYSTEM
After you learn how to operate your tractor, check to see
that the brake is properly adjusted.
See "ro
ADJUST
BRAKE" in the Service and Adjustments
section of this
manual.
7
Advertisement
Table of Contents
