Table of Contents
Advertisement
SERVICE AND ADJUSTMENTS
i
POSITIVE
TERMINAL
NEGATIVE TERMINAL
3HARGED
BATTERY
POSITIVE TERMINAL
NEGATIVE TERMINAL
FIG. 27
REPLACING
BA'n'ERY
(See Figs. 28 and 29
CAUTION:
Do not short batterytermi-
nals by allowing a wrench or any other
_
object to contact both terminals at the
same time. Before connecting battery,
remove metal
bracelets,
wristwatch
bands,rings,etc.
Positive terminal must be connected
first to prevent sparking from acciden-
tal grounding.
Lift seat pan to raised position and open battery box
door.
Disconnect BLACK battery cable first then RED battery
cable and carefully remove battery from tractor.
Install new battery with terminals in same position as
old battery.
First connect RED battery cable to positive (+) terminal
with hex bolt and keps nut as shown. Tighten securely.
Connect BLACK grounding cable to negative (-) termi-
nal with remaining
hex bolt and keps nut. Tighten
securely.
Close battery box door.
BATTERY
BOX DOOR
FIG. 28
KEPS
"_'_"'NUT
HEX
POSITIVE(RED)
CABLE
(BLACK) CABLE
FIG. 29
TO REPLACE
HEADLIGHT
BULB
•
Raise hood.
Pull bulb holder out of the hole in the backside of the
grill.
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
Check wiring.
See electrical wiring diagram
in the
Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse.
The
fuse holder is located behind the dash.
TO REMOVE
HOOD
AND
GRILL
ASSEMBLY
(See
Fig. 30)
Raise hood.
•
Unsnap headlight wire connector.
•
Stand in front oftractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
•
To replace, reverse above procedure.
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 30
24
Advertisement
Table of Contents
