Poulan Pro 2750 Instruction Manual page 13

Using a support stand
2 ndCut
1 st Cut
Using a support stand t st Cut
LIMBING AND PRUNING
_WARNING:
Be alert for and guard
against kickback. Do not allow the moving
chain to contact any other branches or ob-
iects at the nose of the guide bar when limb-
=ng or pruning. A!lowing such contact can re-
sult m senous _njury.
all'WARNING:
Never climbinto atree
to limb or prune• Do not stand on ladders,
platforms, a log, or in any position which can
cause you to lose your balance or control of
the saw.
IMPORTANT POINTS
• Work slowly, keeping beth hands firmly
gripped on the saw• Maintain secure foot-
mg and balance.
• Watch out for springpeles. Use extreme
caution when cuffing small size limbs.
Slender material may catch the saw chain
and be whipped toward you or pull you off
balance•
• Be alert for springback, Watch out for
branches that are bent or under pressure.
Avoid being struck by the branch or the
saw when the tension in the wood fibers is
released,
• Keep a clear work area. Frequently clear
branches out of the way to avoid tripping
over them.
LIMBING
• Always limb a tree after it is cut down, Only
then can limbing be done safely and prop-
erly,
• Leave the larger limbs underneath the
felled tree to support the tree as you work.
• Start at the base of the felled tree and work
toward the top, cutting branches and
limbs, Remove small limbs with one cut.
• Keep the tree between you and the chain•
Cut from the side of the tree opposite the
branch you are cutting.
• Remove larger, supporting branches with
the cutting techniques described in BUCK-
ING WITHOUT A SUPPORT.
• Always use an overcut to cut small and
freely hanging limbs. Undercutting could
cause limbs to fall and pinch the saw.
PRUNING
WARNING:
Limit pruning to limbs
shoulder height or below, Do not cut if
branches are higher than your shoulder. Get
a professional to do the job.
• Make your fist cut 1/3 of the way
through the bottom of the limb•
• Next make a 2nd cut all the way
through the limb. Then cut a third
overcut leaving a 1 to 2 inch collar from
the truck of the tree,
_Th_ Jdic Second cut'_'!t
Collar tit_/
_!l ,/_ First cut
/ Pruning technique
_,WARNING:
Disconnect the spark
plug before performing maintenance except
for carburetor adjustments•
We recommend all service and adjustments
not listed in this manual be performed by an
authorized service dealer•
MAINTENANCE SCHEDULE
Lubricate bar
sprocket hole .....
Check:
Fuel mixture level ,.
Bar lubrication .....
Chain tension .....
Chain sharpness ,.
For damaged parts
For loose caps ....
For loose fasteners.
For loose parts ....
Inspect and Clean:
Bar ................
Complete saw .....
Air filter ...........
•, After each use
Before each use
Before each use
Before each use
Before each use
Before each use
Before each use
Before each use
Before each use
Before each use
After each use
Every 5 hours*
Chain brake ........ Every 5 hours*
Spark arresting screen
and muffler ......... Every 25 hours*
Replace spark plug , Yearly
Replace fuel filter,.. Yearly
* Hours of Operation
AIR FILTER
CAUTION: Do not clean filter in gasoline
or other flammable solvent to avoid creating
a fire hazard or producing harmful evapora-
tive emissions•
13