Storage; Replace Spark Plug; Replace Fuel Filter; Fuel System - Poulan Pro 25 HHT Instruction Manual

NOTE: After adjustment, the washers be-
tween the bolt head and the blade should be
able to be turned by hand, but not loose
enough to move when the unit is tilted from
side to side.
CAUTION: if the clearance between the
cutting blades is set too wide, the blades will
not cut correctly, if the blades are adjusted too
tight, overheating may occur.
REPLACE SPARK PLUG
Replace spark plug each year to ensure the
engine starts easier and runs better. Set
spark plug gap at 0.025 h_ch (0.6 mm). Igni-
tion timing is fixed, nonadjustable.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder and dis-
card.
3. Replace with Champion ROJ-6Y spark
plug and tighten securely with a 3/4 inch
(19 mm) socket wrench.
4. Reinstall the spark plug boot.
REPLACE FUEL FILTER
To replace fuel filter, drain unit by running it dry
of fuel, then remove fuel cap/retainer assem-
bly from tank. Pull filter from tank and remove
it from the fuel line. Install new fuel filter on fuel
line; reinstall parts.
Fuel Line
Fuel
Filter
'nWARNING:
Perform the following
steps after each use:
• Allow engine to cool, and secure the unit
before storh_g or transporting.
• Store unit and fuel h_awell ventilated area
where fuel vapors cannot reach sparks or
open flames from water heaters, electric
motors or switches, furnaces, etc.
• Store unit with the blade cover installed.
Position unit so that any sharp object can-
not accidentally cause injury.
• Store unit and fuel well out of the reach of
children.
SEASONAL STORAGE
Prepare unit for storage at end of season or if
it will not be used for 30 days or more.
If your unit is to be stored for a period of time:
• Clean the entire unit.
• Store in a clean dry area.
• Clean all parts and check for damage.
Have damaged parts repaired or replaced
by an authorized service dealer,
• Keep all nuts, bolts, and screws tight.
• Lightly oil external metal surfaces, includ-
ing the blade.
• Install the blade cover.
To oil the blade, do the following:
• Stop the engine and allow blade to come to
a complete stop.
• Ensure ON/OFF switch is in the OFF posi-
tion.
• Disconnect the spark plug wire.
• Apply a light machine oil along the edge of
the top strap as shown.
FUEL SYSTEM
Under FUELING ENGINE in the OPERA-
TION section of this manual, see message la-
beled iMPORTANT regarding the use of ga-
sohol in your engine. Fuel stabilizer is an ac-
ceptable alternative in minimizing the formation
of fuel gum deposits during storage. Add stabi-
lizer to gasoline in fuel tank or fuel storage con-
tainer. Follow the mix instructions found on sta-
bilizer container, Run engine at least 5 minutes
after adding stabilizer,
HELPFUL TIP I
During etorage of your gas/ I
___t'el_!_&" _ ofl mixture, the oil will sepa- J
I_*'_l_ rate from the gas. I
IFJIr'.J_) we recommend t hatyou I
_ shake the gas cat? weekly
I
to insure proper blending of I
the gas and oil.
-8-