Table of Contents
Advertisement
ASSEMBLY
INSTALL
SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
•
Remove adjustment
knob and flat washer securing
seat to cardboard packing and set aside for assembly
of seat to tractor.
•
Pivot seat upward and remove from the cardboard pack-
ing. Remove the cardboard packing and discard.
•
Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan.
•
Push down on seat to engage shoulder bolt in slot and
pull seat towards rear of tractor.
•
Pivot seat and pan forward and assemble adjustment
knob and flat washer loosely. Do not tighten.
•
Lower seat into operating position and sit on seat.
•
Slide seat until a comfortable
position is reached
which allows you to press clutch/brake pedal all the
way down.
•
Get off seat without moving its adjusted position.
•
Raise seat and tighten adjustment knob securely.
SEAT
SEAT PAN _4\
SHOULDER
BOLT
FLAT WASHER
KNOB
FIG. 3
NOTE: You may now roll or drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
TO ROLL TRACTOR
OFF SKID
(See Op-
eration
section
for location
and function
of
controls)
•
Press lift lever plunger and raise attachment lift lever
to its highest position.
•
Release parking brake by depressing brake pedal.
•
Place freewheel control in "transmission disengaged
position" (See "TO TRANSPORT"
in the Operation
section of this manual).
•
Roll tractor forward off skid.
TO DRIVE TRACTOR
OFF SKID (See Op-
eration
section
for location
and function
of
controls)
_I_WARNING: Before starting, read, understand and follow
all instructions in the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other people and objects.
•
Be sure all the above assembly steps have been com-
pleted.
•
Check engine oil level and fill fuel tank with gasoline.
•
Place freewheel control in "transmission
engaged"
position (see "TO TRANSPORT" in Operation section
of this manual).
•
Sit on seat in operating position, depress brake pedal
and set the parking brake.
•
Place motion control lever in neutral (N) position.
•
Press lift lever plunger and raise attachment lift lever
to its highest position.
•
Start the engine.After engine has started, movethrottle
control to idle position.
•
Release parking brake.
•
Slowly move the motion control lever forward and slowly
drive tractor off skid.
•
Apply brake to stop tractor, set parking brake and place
motion control lever in neutral position.
•
Turn ignition key to "STOP" position.
Continue with the instructions that follow.
ASSEMBLE
GAUGE
WHEELS
TO MOWER
DECK (See Fig. 4)
The gauge wheels are designed to keep the mower deck in
proper posit ionwhen operating mower.Be sure they are properly
adjusted to ensure optimum mower performance.
•
Slide gauge wheel bar down into bracket channel, Be sure
that gauge wheel bar aligning holes are on top. Assemble
gauge wheels as shown using shoulder bolts, 3/8 washers
and 3/8-16 center Iocknuts and tighten securely.
•
For ease of mower to tractor assembly, raise gauge
wheels to highest position and retain with clevis pins
and spring retainers.
•
Adjust gauge wheels before operating mower. See "TO
ADJUST GAUGE WHEELS" in the Operation section
of this manual.
RETAINER SPRING
PIN
FIG. 4
7
Advertisement
Table of Contents
Troubleshooting
