Table of Contents
Advertisement
ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping pur-
poses. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened
securely. Use the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(2) 9/16" wrench
Utility knife
(1) 1/2" wrench
Tire pressure gauge
(1) 3/4" wrench
Pliers
(1) 3/4" socket with drive ratchet
When right or left hand is mentioned in this manual, it means
when you are in the operating position (seated behind the
steering wheel).
TO REMOVE TRACTOR
FROM
CARTON
UNPACK CARTON
•
Remove all accessible loose parts and parts cartons
from carton.
•
Cut along dotted lines on all four panels of carton.
Remove end panels and lay side panels flat.
•
Remove mower and packing materials.
•
Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR
FROM
SKID
ATTACH STEERING
WHEEL (See Fig. 1)
•
Remove Iocknut and large flat washer from steering
shaft.
•
Position front wheels of the tractor so they are pointing
straight forward.
•
Slide the steering sleeve over the steering shaft.
•
Align tabs and press steering sleeve extension into
bottom of steering wheel.
•
Position steering wheel so cross bars are horizontal
(left to right) and slide onto steering wheel adapter.
•
Secure steering wheel to steering shaft with Iocknut
and large flat washer previously
removed.
Tighten
securely.
•
Snap steering wheel insert into center of steering
wheel.
•
Remove protective materials from tractor hood and
grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN
SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR ISTO
ROLL OFF SKID.
STEERING
SLEEVE
FIG. 1
HOW TO SET UP YOUR TRACTOR
CHECK BATTERY
(See Fig. 2)
•
Lift hood to raised position.
•
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in MAINTENANCE
section of this
manual for charging instructions).
LABEL
FIG. 2
6
Advertisement
Table of Contents
Troubleshooting
